Skip to contentSkip to conversation

am335x uart boot

DISCUSSION Matwey V. Kornilov 1 participant 2 messages Oct 12, 2020 – Oct 17, 2020

lore
Share & tools
lore
#0 lore raw

Hello,

I am trying to provide u-boot via uart to am335x bootrom (I use BeagleBone Black board). Has anyone succeeded on it?

The CPU technical reference says that I have to use X-Modem 1K to load the firmware. I am trying to reach this with screen and sx command.

In the serial console I see transmission invitation from the hardware
side: 'C'.
When I use sx --1k -X to transmit the binary there are no data accepted. When I use sx -X (with 128 byte frame) the transmission is running until hardware sends "Cancel" command in the middle.

I've also tried minicom terminal. It behaves like X-Modem 128 byte transmission with no success.

#1 lore raw

12.10.2020 11:39, Matwey V. Kornilov ?????:

Quoted 8 lines

Hello,

I am trying to provide u-boot via uart to am335x bootrom (I use BeagleBone Black board). Has anyone succeeded on it?

The CPU technical reference says that I have to use X-Modem 1K to load the firmware. I am trying to reach this with screen and sx command.

Quoted 10 lines

In the serial console I see transmission invitation from the hardware
side: 'C'.
When I use sx --1k -X to transmit the binary there are no data accepted. When I use sx -X (with 128 byte frame) the transmission is running until hardware sends "Cancel" command in the middle.

I've also tried minicom terminal. It behaves like X-Modem 128 byte transmission with no success.

Now I believe this was due to transmission errors. I've taken another RS232 converter and now everything boots both with sx -X and sx --1k -X