Skip to contentSkip to conversation

SIS900 module detects two transceivers, picks the wrong one

DISCUSSION Cameron Goble 2 participants 2 messages Feb 3, 2003

lore
Share & tools
lore
#0 lore raw

Hello,

I am having trouble with the SIS900 driver module v1.08.04. The module installs correctly and does not return an error, but ... well...

Perhaps dmesg will explain better:

eth0: AMD79C901 HomePNA PHY transceiver found at address 2.
eth0: AMD79C901 10BASE-T PHY transceiver found at address 3.
eth0: using transceiver found at address 2 as default
eth0: SiS 900 PCI Fast Ethernet at 0xec400, IRQ 11, 00:30:67:09:53:81.

So the network interface is a multi-function device, built onto the motherboard. The driver picks the HomePNA transceiver, but I want to use the 10BASE-T transceiver. Is there an option I can pass, or some code I can edit that force the driver to pick the 10BASE-T transceiver at address 3?

I have attempted to manually configure the device with ifconfig, but I get the feeling that ifconfig talks to the hardware through the driver, and since the driver is pointing to the wrong place... I have gotten nowhere with that approach.

This is an AMD EasyNow PC -- The POST does not display useful information (it's a graphic of the computer that lights up). I have yet to find a way into the BIOS configuration screen, or I would try turning the HomePNA device off from there.

The documentation for this module lists [email protected] and [email protected] as maintainers for the SIS900 module, but my e-mail to them apparently did not go through.

Thanks in advance for any help that can be offered. Please cc: replies to me at [email protected] .
Cameron Goble
Albuquerque NM USA
[email protected]

#1 lore raw
Quoted 12 lines · Cameron Goble

Hello,

I am having trouble with the SIS900 driver module v1.08.04. The module installs correctly and does not return an error, but ... well...

Perhaps dmesg will explain better:

eth0: AMD79C901 HomePNA PHY transceiver found at address 2.
eth0: AMD79C901 10BASE-T PHY transceiver found at address 3.
eth0: using transceiver found at address 2 as default
eth0: SiS 900 PCI Fast Ethernet at 0xec400, IRQ 11, 00:30:67:09:53:81.

Quoted 6 lines

So the network interface is a multi-function device, built onto the motherboard. The driver picks the HomePNA transceiver, but I want to use the 10BASE-T transceiver. Is there an option I can pass, or some code I can edit that force the driver to pick the 10BASE-T transceiver at address 3?

The HomePNA protocol usually uses the exact same kind of wire at 10BASE-T. It's just wired differently. I don't think you have two such connectors on your board.

This looks as though your wire is just connected backwards, i.e., you have a reversed patch-cord.

Are you connected to a Hub? Does the LED on the hub show that the wire is connected properly an does the LED on/near the connector on your PC show that its connected correctly also?

If you really do have to such connectors, just use eth1 instead of eth0, i.e., ifconfig eth1 ip-address ...

Cheers,
Dick Johnson
Penguin : Linux version 2.4.18 on an i686 machine (797.90 BogoMips). Why is the government concerned about the lunatic fringe? Think about it.