Skip to contentSkip to conversation

sd, scsi_lib: fix recognition of cache type of Initio SBP-2 bridges

PATCH In review Stefan Richter 1 participant 1 message Feb 23, 2006 SCSI

lore
Share & tools
lore
#0 lore raw

PATCH 2/2 sd, scsi_lib: fix recognition of cache type of Initio SBP-2 bridges

sd, scsi_lib: fix recognition of cache type of Initio SBP-2 bridges

Regardless what mode page was asked for, Initio INIC-14x0 and INIC-2430 always return page 6 without mode page headers. Check for this breakage in scsi_mode_sense().

Taken from a patch by Al Viro <[email protected]>.
http://marc.theaimsgroup.com/?l=linux-scsi&m=114055884611429

---
Depends on patch "sd: fix memory corruption by sd_read_cache_type".

This cache type fix is applicable to 2.6.14, 2.6.15, and 2.6.16 as well but is definitely of less importance than the memory corruption patch.

drivers/scsi/scsi_lib.c +11 -2
Index: linux-2.6.16-rc4/drivers/scsi/scsi_lib.c
===================================================================
@@ -1893,8 +1893,16 @@ scsi_mode_sense(struct scsi_device *sdev
 	}
 
 	if(scsi_status_is_good(result)) {
-		data->header_length = header_length;
-		if(use_10_for_ms) {
+		if (unlikely(buffer[0] == 0x86 && buffer[1] == 0x0b &&
+			     (modepage == 6 || modepage == 8))) {
+			/* Initio breakage? */
+			header_length = 0;
+			data->length = 13;
+			data->medium_type = 0;
+			data->device_specific = 0;
+			data->longlba = 0;
+			data->block_descriptor_length = 0;
+		} else if(use_10_for_ms) {
 			data->length = buffer[0]*256 + buffer[1] + 2;
 			data->medium_type = buffer[2];
 			data->device_specific = buffer[3];
@@ -1907,6 +1915,7 @@ scsi_mode_sense(struct scsi_device *sdev
 			data->device_specific = buffer[2];
 			data->block_descriptor_length = buffer[3];
 		}
+		data->header_length = header_length;
 	}
 
 	return result;
drivers/scsi/sd.c +6 -0
Index: linux-2.6.16-rc4/drivers/scsi/sd.c
===================================================================
@@ -1328,6 +1328,12 @@ sd_read_cache_type(struct scsi_disk *sdk
 	if (!scsi_status_is_good(res))
 		goto bad_sense;
 
+	if (!data.header_length) {
+		modepage = 6;
+		printk(KERN_ERR "%s: missing header in MODE_SENSE response\n",
+		       diskname);
+	}
+
 	/* that went OK, now ask for the proper length */
 	len = data.length;