Documentation: correction to debugging-via-ohci1394
PATCH 1/1 Documentation: correction to debugging-via-ohci1394
Rectify a factoid about firewire-ohci.
Signed-off-by Stefan Richter <[email protected]>
---
Ingo, I can get this to Linus via linux1394-2.6.git.
Documentation/debugging-via-ohci1394.txt | 13 +++++++------ 1 file changed, 7 insertions(+), 6 deletions(-)
Documentation/debugging-via-ohci1394.txt +7 -6
@@ -36,13 +36,14 @@ available (notebooks) or too slow for ex Drivers ------- -The OHCI-1394 drivers in drivers/firewire and drivers/ieee1394 initialize -the OHCI-1394 controllers to a working state and can be used to enable -physical DMA. By default you only have to load the driver, and physical -DMA access will be granted to all remote nodes, but it can be turned off -when using the ohci1394 driver. +The ohci1394 driver in drivers/ieee1394 initializes the OHCI-1394 controllers +to a working state and enables physical DMA by default for all remote nodes. +This can be turned off by ohci1394's module parameter phys_dma=0. -Because these drivers depend on the PCI enumeration to be completed, an +The alternative firewire-ohci driver in drivers/firewire uses filtered physical +DMA, hence is not yet suitable for remote debugging. + +Because ohci1394 depends on the PCI enumeration to be completed, an initialization routine which can runs pretty early (long before console_init(), which makes the printk buffer appear on the console can be called) was written.
Signature · 3 lines
Stefan Richter -=====-==--- --=- =--=- http://arcgraph.de/sr/
Quoted 5 lines · Stefan Richter
Rectify a factoid about firewire-ohci.
Signed-off-by Stefan Richter <[email protected]>---
Ingo, I can get this to Linus via linux1394-2.6.git.
please do, thanks.
Acked-by Ingo Molnar <[email protected]>
Ingo