Skip to contentSkip to conversation

hardware raid (adaptec 1200A)?

DISCUSSION [email protected] 3 participants 3 messages Nov 15, 2001 – Nov 16, 2001

lore
Share & tools
lore
#0 lore raw

I'm setting up a new machine with a pair of IDE drives connected to adaptec 1200A controller. I defined a RAID-0 array using the adaptec bios, but linux doesn't see it as a single drive. It just sees two drive, hde and hdg (each at their physical sizes). Any hints?

#1 lore raw

Not conversant with the 1200 as such, but in any hardware raid, Linux should always see it as a single drive.. Otherwise you simply have not set up the RAID device correctly..

Quoted 11 lines · On Thu, 2001-11-15 at 12:15, [email protected] wrote:

I'm setting up a new machine with a pair of IDE drives connected to adaptec 1200A controller. I defined a RAID-0 array using the adaptec bios, but linux doesn't see it as a single drive. It just sees two drive, hde and hdg (each at their physical sizes). Any hints? -
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

Signature · 9 lines
"Catch the Magic of Linux..."
--------------------------------------------------------
Michael Peddemors - Senior Consultant
LinuxAdministration - Internet Services
NetworkServices - Programming - Security
Wizard IT Services http://www.wizard.ca
Linux Support Specialist - http://www.linuxmagic.com
--------------------------------------------------------
(604)589-0037 Beautiful British Columbia, Canada
#2 lore raw
In reply to [email protected]
Quoted 5 lines · [email protected] wrote:

I'm setting up a new machine with a pair of IDE drives connected to adaptec 1200A controller. I defined a RAID-0 array using the adaptec bios, but linux doesn't see it as a single drive. It just sees two drive, hde and hdg (each at their physical sizes). Any hints?

I think the adaptec 1200A is just another low-cost not-quite-hardware-raid controller. As far as I have heared it is based on Highpoint-Tech's HPT370. There is raid-0 support implemented in the kernel.

be sure to enable CONFIG_BLK_DEV_ATARAID_HPT=y

The volumes should show up as /dev/ataraid/d[0-9]p[0-9] (major blockdevice number 114).

bye,
Wilfried

Signature · 2 lines
Terorists crashed an airplane into the server room, have to remove
/bin/laden. (rm -rf /bin/laden)