Why my image isn't boot?
I want it run from flash, but if I use "loadb 0x00100000", after transfer
the uImage, "md 0x00100000" shows that flash data is wrong, what should I do?
Hongda Zhao
Quoted 30 lines
----- Original Message -----
From: <[email protected]>
To: "Zhao Hongda" <[email protected]>
Sent: Tuesday, April 08, 2003 5:23 AM
Subject: Re: [U-Boot-Users] Why my image isn't boot?Quoted 5 lines
Quoted 5 lines
I use the u-boot cvs source,
linux-2.4.19 kernel, arm-linux patch, and xscale patch. arm-linux-gcc 3.0 as complier,lubbock(pxa250) as platform.arm-linux-objcopy -O binary -R .note -R .comment -S vmlinux
linux.bin
Quoted 2 lines
Quoted 2 lines
gzip -9 linux.bin
mkimage -A arm -O linux -T kernel -C gzip -a0xa0008000-e
0xa0008000-nQuoted 13 lines
Quoted 7 lines
"Linux Kernel Image" -d linux.bin.gz uImage
then under u-boot:=>loadb 0xa0008000 (send the uImage) =>go 0xa0008000 start the application at 0xa0008000 <hang>You try to start a compressed kernel from RAM?
Rick