Problems with Woody on 710.
Hi,
after searching the mailing list I've found some messages which reported success in installing Woody on a 710. So I tried to install it. After trying many many different lifimages, all ended up in the same result:
It hung during installation ( while mounting the root file system ). Switching to another console ( which still worked ) showed me that /sbin/dbootstrap and [scsi_eh_0] were both in state D.
What did I do wrong ? Or to put it other words: How did you guys get your 710s up'n'running ?
Thanks.
Quoted 8 lines · On 26 Jan 2003 16:44:40 +0100 "Buffalo Bill" <[email protected]> wrote:
Hi,
after searching the mailing list I've found some messages which reported success in installing Woody on a 710. So I tried to install it. After trying many many different lifimages, all ended up in the same result: It hung during installation ( while mounting the root file system ). Switching to another console ( which still worked ) showed me that/sbin/dbootstrap and [
scsi_eh_0] were both in state D.
If you can switch to another console then the system _isn't_ hung.
I saw the same kind of problem on boxes with low amount of RAM (<32M). Though the fact that [scsi_eh_0] is in D state isn't good at all. Maybe you have a problem with your SCSI chain (hard disk, termination problem...?)
Quoted 3 lines
What did I do wrong ? Or to put it other words: How did you guys get your 710s up'n'running ?
The 710 we have running here runs a preinstalled filesystem. That is to say, the HD was prepared in another box and then plugged back into the 710.
Thibaut VARENE
The PA/Linux ESIEE Team
http://pateam.esiee.fr/
Am Son, 2003-01-26 um 17.03 schrieb Thibaut VARENE:
Quoted 1 line
If you can switch to another console then the system _isn't_ hung.
Well, okay the System isn't hung, but the installer.
Quoted 1 line
I saw the same kind of problem on boxes with low amount of RAM (<32M).
My machine has only 48 MBs
Quoted 3 lines
Though the fact that [
scsi_eh_0] is in D state isn't good at all. Maybe you have a problem with your SCSI chain (hard disk, termination problem...?)
It doesn't seem to be a HW problem, since the machine was running HP-UX 10.20 perfectly until i tried to install woody. :-(
Quoted 3 lines
The 710 we have running here runs a preinstalled filesystem. That is to say, the HD was prepared in another box and then plugged back into the 710.
Hmm... i have only one single PA-RISC machine :-(
Thank you for answering.