Skip to contentSkip to conversation

Problems with Woody on 710.

parisc-linux Buffalo Bill 2 participants 3 messages Jan 26, 2003

lore
Share & tools
lore
#0 lore raw

Hi,

after searching the mailing list I've found some messages which reported success in installing Woody on a 710. So I tried to install it. After trying many many different lifimages, all ended up in the same result:
It hung during installation ( while mounting the root file system ). Switching to another console ( which still worked ) showed me that /sbin/dbootstrap and [scsi_eh_0] were both in state D.

What did I do wrong ? Or to put it other words: How did you guys get your 710s up'n'running ?

Thanks.

#1 lore raw
Quoted 8 lines · On 26 Jan 2003 16:44:40 +0100 "Buffalo Bill" <[email protected]> wrote:

Hi,

after searching the mailing list I've found some messages which reported success in installing Woody on a 710. So I tried to install it. After trying many many different lifimages, all ended up in the same result: It hung during installation ( while mounting the root file system ). Switching to another console ( which still worked ) showed me that/sbin/dbootstrap and [scsi_eh_0] were both in state D.

If you can switch to another console then the system _isn't_ hung.

I saw the same kind of problem on boxes with low amount of RAM (<32M). Though the fact that [scsi_eh_0] is in D state isn't good at all. Maybe you have a problem with your SCSI chain (hard disk, termination problem...?)

Quoted 3 lines

What did I do wrong ? Or to put it other words: How did you guys get your 710s up'n'running ?

The 710 we have running here runs a preinstalled filesystem. That is to say, the HD was prepared in another box and then plugged back into the 710.

Thibaut VARENE
The PA/Linux ESIEE Team
http://pateam.esiee.fr/

#2 lore raw

Am Son, 2003-01-26 um 17.03 schrieb Thibaut VARENE:

Quoted 1 line

If you can switch to another console then the system _isn't_ hung.

Well, okay the System isn't hung, but the installer.

Quoted 1 line

I saw the same kind of problem on boxes with low amount of RAM (<32M).

My machine has only 48 MBs

Quoted 3 lines

Though the fact that [scsi_eh_0] is in D state isn't good at all. Maybe you have a problem with your SCSI chain (hard disk, termination problem...?)

It doesn't seem to be a HW problem, since the machine was running HP-UX 10.20 perfectly until i tried to install woody. :-(

Quoted 3 lines

The 710 we have running here runs a preinstalled filesystem. That is to say, the HD was prepared in another box and then plugged back into the 710.

Hmm... i have only one single PA-RISC machine :-(

Thank you for answering.