Bridging Firewall
Hi All,
I am trying to set up a bridging firewall with Red Hat 8.0. I can not get packets to flow from nic to nic.
Topology:
br0
|
|
------
| |eth1 eth2
Here are the steps I have taken to setup the bridge:
ifdown eth1
ifdown eth2
ifconfig eth1 0.0.0.0
ifconfig eth2 0.0.0.0
brctl addbr br0
brctl addif br0 eth1
brctl addif br0 eth2
ifconfig br0 0.0.0.0
When I ifconfig br0 I can see that rx packets are incrementing but tx packets are not incrementing. Are there any known issues with RH8.0 and brdiging? Thanks for helping.
Andy
you forgot one step, the whole procedure is like this:
brctl addbr br0
brctl addif br0 eth0
brctl addif br0 eth1
ifconfig eth0 0.0.0.0 promisc
ifconfig eth1 0.0.0.0 promisc
ifconfig br0 up
ip link set eth0 up
ip addr add 172.16.41.211/24 brd + dev br0
ip route add default via 172.16.41.250
Quoted 36 lines · Andrew J. Meader
Hi All,
I am trying to set up a bridging firewall with Red Hat 8.0. I can not get packets to flow from nic to nic.
Topology:
br0 | | ------ | | eth1 eth2Here are the steps I have taken to setup the bridge:
ifdown eth1
ifdown eth2ifconfig eth1 0.0.0.0
ifconfig eth2 0.0.0.0brctl addbr br0
brctl addif br0 eth1
brctl addif br0 eth2ifconfig br0 0.0.0.0
When I ifconfig br0 I can see that rx packets are incrementing but tx packets are not incrementing. Are there any known issues with RH8.0 and brdiging? Thanks for helping.
Andy