Skip to contentSkip to conversation

Bridging Firewall

DISCUSSION Andrew J. Meader 2 participants 2 messages Mar 27, 2003

lore
Share & tools
lore
#0 lore raw

Hi All,

I am trying to set up a bridging firewall with Red Hat 8.0. I can not get packets to flow from nic to nic.

Topology:

            br0
               |
               |
       ------
       |                |

eth1 eth2

Here are the steps I have taken to setup the bridge:

ifdown eth1
ifdown eth2

ifconfig eth1 0.0.0.0
ifconfig eth2 0.0.0.0

brctl addbr br0

brctl addif br0 eth1
brctl addif br0 eth2

ifconfig br0 0.0.0.0

When I ifconfig br0 I can see that rx packets are incrementing but tx packets are not incrementing. Are there any known issues with RH8.0 and brdiging? Thanks for helping.

Andy

#1 lore raw

you forgot one step, the whole procedure is like this:

brctl addbr br0
brctl addif br0 eth0
brctl addif br0 eth1
ifconfig eth0 0.0.0.0 promisc
ifconfig eth1 0.0.0.0 promisc
ifconfig br0 up

ip link set eth0 up

ip addr add 172.16.41.211/24 brd + dev br0
ip route add default via 172.16.41.250

Quoted 36 lines · Andrew J. Meader

Hi All,

I am trying to set up a bridging firewall with Red Hat 8.0. I can not get packets to flow from nic to nic.

Topology:

             br0
                |
                |
        ------
        |                |
    eth1          eth2

Here are the steps I have taken to setup the bridge:

ifdown eth1
ifdown eth2

ifconfig eth1 0.0.0.0
ifconfig eth2 0.0.0.0

brctl addbr br0

brctl addif br0 eth1
brctl addif br0 eth2

ifconfig br0 0.0.0.0

When I ifconfig br0 I can see that rx packets are incrementing but tx packets are not incrementing. Are there any known issues with RH8.0 and brdiging? Thanks for helping.

Andy