kernel starting...
My U-BOOT seems to be running!
(U_BOOT 1.1.4 and linux 2.6.10)
Now I?m trying to run linux on my ARM board but I get no output on my console!
What params I?ve to pass from U-BOOT to Linux to become an output ?
U-boot is uncompressing Kernelheader and shows kernel starting...
I read the faq
http://www.denx.de/wiki/view/DULG/LinuxKernelIgnoresMyBootargs
http://www.denx.de/wiki/view/DULG/LinuxUncompressingError
I tried to load the Image on a higher RAM addres. But not effect! I is still the same problem.
http://www.denx.de/wiki/view/DULG/LinuxHangsAfterUncompressingKernel
I couldn?t found IMAP_ADDR and CFG_IMMR
At the moment I?m not using any fs!
--
View this message in context: http://www.nabble.com/kernel+starting...-t1676914.html#a4547030
Sent from the Uboot - Users forum at Nabble.com.
Quoted 10 lines · Hurricane555 wrote:
My U-BOOT seems to be running!
(
U_BOOT1.1.4 and linux 2.6.10)Now I?m trying to run linux on my ARM board but I get no output on my console!
What params I?ve to pass from U-BOOT to Linux to become an output ?U-boot is uncompressing Kernelheader and shows kernel starting...
For example, Set 'console=/dev/ttyS0,115200' from the bootargs.
Kevin
Quoted 1 line
Quoted 1 line
For example, Set 'console=/dev/ttyS0,115200' from the bootargs.
I already inserted this line! my console is like this:
console=/dev/ttyS0,9600
Any other Bootargs or some thing else?
Is this CONFIG_SERIAL_TAG also necessary?
--
View this message in context: http://www.nabble.com/kernel+starting...-t1676914.html#a4556222
Sent from the Uboot - Users forum at Nabble.com.