Skip to contentSkip to conversation

EEpro100 bug in 2.2.18

DISCUSSION Andriy Korud 2 participants 2 messages Feb 14, 2001

lore
Share & tools
lore
#0 lore raw

Hello all,
My setup is Intel 440GX MB with intergrated EEPro100. When using Linux 2.2.18 the following happen: after reboot, I got:

     eepro100: cmd_wait for (0xffffff90) timedout with (0xffffff90)!

and NIC is dead.
After power cycle, first boot works fine and all following boots (without power off) - see above. Very seldom (I've noticed this 2 times during 2 monthes) this happen during normal operation.

2.2.12 and 2.4.x runs without problem (but have other problems which it unusable for me).

Signature · 2 lines
Best regards,
 Andriy                          mailto:[email protected]
#1 lore raw
Quoted 4 lines · Andriy Korud

Hello all,
My setup is Intel 440GX MB with intergrated EEPro100. When using Linux 2.2.18 the following happen: after reboot, I got:

     eepro100: cmd_wait for (0xffffff90) timedout with (0xffffff90)!

I reported the same hassle a while back. A patch was suggested and am using it now. It's in the thread titled 'eepro100 + 2.2.18 + laptop problems'.

Quoted 3 lines

After power cycle, first boot works fine and all following boots (without power off) - see above. Very seldom (I've noticed this 2 times during 2 monthes) this happen during normal operation.

I jsut take the interface down and up and eventually it goes ok. It doesn't happen all the time either.

Signature · 5 lines
CaT ([email protected])		*** Jenna has joined the channel.
				<cat> speaking of mental giants..
				<Jenna> me, a giant, bullshit
				<Jenna> And i'm not mental
					- An IRC session, 20/12/2000