Skip to contentSkip to conversation

at91: Add CAN init function

PATCH New Daniel Gorsulowski 1 participant 1 message Jun 29, 2009 Arm/Microchip (AT91) SoC support

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 at91: Add CAN init function

To enable CAN init, CONFIG_CAN has to be defined in the board config file and at91_can_hw_init() has to be called in the board specific code.

CAN is available on AT91SAM9263 and AT91CAP9 SoC.

---
 cpu/arm926ejs/at91/at91cap9_devices.c    |   11 +++++++++++
 cpu/arm926ejs/at91/at91sam9263_devices.c |   11 +++++++++++
 include/asm-arm/arch-at91/at91_common.h  |    1 +
 3 files changed, 23 insertions(+), 0 deletions(-)
cpu/arm926ejs/at91/at91cap9_devices.c +11 -0
index c0024ac..ede55f4 100644
@@ -174,3 +174,14 @@ void at91_macb_hw_init(void)
 #endif
 }
 #endif
+
+#ifdef CONFIG_CAN
+void at91_can_hw_init(void)
+{
+	at91_set_A_periph(AT91_PIN_PA12, 0);	/* CAN_TX */
+	at91_set_A_periph(AT91_PIN_PA13, 1);	/* CAN_RX */
+
+	/* Enable clock */
+	at91_sys_write(AT91_PMC_PCER, 1 << AT91CAP9_ID_CAN);
+}
+#endif
cpu/arm926ejs/at91/at91sam9263_devices.c +11 -0
index 0f2613e..3990dde 100644
@@ -182,3 +182,14 @@ void at91_uhp_hw_init(void)
 	at91_set_gpio_output(AT91_PIN_PA24, 0);
 }
 #endif
+
+#ifdef CONFIG_CAN
+void at91_can_hw_init(void)
+{
+	at91_set_A_periph(AT91_PIN_PA13, 0);	/* CAN_TX */
+	at91_set_A_periph(AT91_PIN_PA14, 1);	/* CAN_RX */
+
+	/* Enable clock */
+	at91_sys_write(AT91_PMC_PCER, 1 << AT91SAM9263_ID_CAN);
+}
+#endif
include/asm-arm/arch-at91/at91_common.h +1 -0
index 9c4e019..01840ee 100644
@@ -25,6 +25,7 @@
 #ifndef AT91_COMMON_H
 #define AT91_COMMON_H
 
+void at91_can_hw_init(void);
 void at91_macb_hw_init(void);
 void at91_serial_hw_init(void);
 void at91_serial0_hw_init(void);
Signature · 1 line
1.5.3