at91: Add CAN init function
PATCH 1/1 at91: Add CAN init function
To enable CAN init, CONFIG_CAN has to be defined in the board config file and at91_can_hw_init() has to be called in the board specific code.
CAN is available on AT91SAM9263 and AT91CAP9 SoC.
Signed-off-by Daniel Gorsulowski <[email protected]>
--- cpu/arm926ejs/at91/at91cap9_devices.c | 11 +++++++++++ cpu/arm926ejs/at91/at91sam9263_devices.c | 11 +++++++++++ include/asm-arm/arch-at91/at91_common.h | 1 + 3 files changed, 23 insertions(+), 0 deletions(-)
cpu/arm926ejs/at91/at91cap9_devices.c +11 -0
@@ -174,3 +174,14 @@ void at91_macb_hw_init(void) #endif }#endif + +#ifdef CONFIG_CAN +void at91_can_hw_init (void ) +{ +at91_set_A_periph (AT91_PIN_PA12 ,0 );/* CAN_TX */ +at91_set_A_periph (AT91_PIN_PA13 ,1 );/* CAN_RX */ + +/* Enable clock */ +at91_sys_write (AT91_PMC_PCER ,1 <<AT91CAP9_ID_CAN ); +} +#endif
cpu/arm926ejs/at91/at91sam9263_devices.c +11 -0
@@ -182,3 +182,14 @@ void at91_uhp_hw_init(void) at91_set_gpio_output(AT91_PIN_PA24, 0); }#endif + +#ifdef CONFIG_CAN +void at91_can_hw_init (void ) +{ +at91_set_A_periph (AT91_PIN_PA13 ,0 );/* CAN_TX */ +at91_set_A_periph (AT91_PIN_PA14 ,1 );/* CAN_RX */ + +/* Enable clock */ +at91_sys_write (AT91_PMC_PCER ,1 <<AT91SAM9263_ID_CAN ); +} +#endif
include/asm-arm/arch-at91/at91_common.h +1 -0
@@ -25,6 +25,7 @@#ifndef AT91_COMMON_H #define AT91_COMMON_H +void at91_can_hw_init (void );void at91_macb_hw_init (void );void at91_serial_hw_init (void );void at91_serial0_hw_init (void );
Signature · 1 line
1.5.3