mtd: m25p80: disable SST software protection bits by default
PATCH 1/1 mtd: m25p80: disable SST software protection bits by default
From: Graf Yang <[email protected]>
The SST SPI flashes is like Atmel SPI flashes in that the software protection bits are set by default at power up, so clear them at init time.
Signed-off-by Graf Yang <[email protected]>
Signed-off-by Mike Frysinger <[email protected]>
---
i could have sworn i sent this out, but i cant find it in my e-mail log
drivers/mtd/devices/m25p80.c | 7 ++++--- 1 files changed, 4 insertions(+), 3 deletions(-)
drivers/mtd/devices/m25p80.c +4 -3
@@ -775,11 +775,12 @@ static int __devinit m25p_probe(struct spi_device *spi)dev_set_drvdata (&spi->dev, flash);/* -* Atmel serial flash tend to power up -* with the software protection bits set +* Atmel and SST serial flash tend to power +* up with the software protection bits set */ -if (info->jedec_id >>16 ==0x1f ) { +if (info->jedec_id >>16 ==0x1f || + info->jedec_id >>16 ==0xbf ) {write_enable (flash);write_sr (flash,0 ); }
Signature · 1 line
1.6.5.rc1