Skip to contentSkip to conversation

Warning: unable to open an initial console

DISCUSSION Steven A. DuChene 1 participant 1 message Sep 30, 2009

lore
Share & tools
lore
#0 lore raw

Well, according to the research I did looking for my initial console error message on google it seems it is not a kernel compile issue but rather an issue with the kernel needing to find /dev/console before udev is run to create the various device entries in /dev

To work around this I created an initrd file for my kernel even though I have all the needed disk device drivers and filesystems drivers in my kernel. Once I did that and put it into place my new kernel booted up just fine.

-----Original Message-----

Quoted 18 lines

From: "Steven A. DuChene" <[email protected]>
Sent: Sep 30, 2009 1:05 PM
To: [email protected]
Subject: Warning: unable to open an initial console

Hmm, I tried various combonations of turning off the framebuffer support all together and then turning it back on with various drivers (nvidia or vesa vga) but still I get the same message about "Warning: unable to open an initial console."

Anything else I should be looking at besides the graphics support part of the drivers section of the kernel config?

Again this is a fairly standard PCChips A13G motherboard with NVidia chipset and AMD Athlon 3600+ CPU that works fine with the regular distro supplied FC9 kernel (2.6.25-14.fc9.x86_64) and I have the x86_64 version of FC9 installed.