Skip to contentSkip to conversation

SAA7146-based card- tunes, but no multiplex

linux-dvb Dietmar Nowack 1 participant 1 message Sep 22, 2010 Media (V4L/DVB)

lore
Share & tools
lore
#0 lore raw

Hi all,
I have an (old) SAA7146-based DVB device- a Technotrend/Hauppauge WinTV DVB-S rev1.3 SE, if the autodetection is to be trusted. It is recognized without error (apparently), the firmware file resides in the appropriate folder and is loaded correctly, and nothing in the logs points to an error. However, while the device tunes and acquires a lock, no video data can be captured.

Here's what I think are the relevant messages from the kernel:

[   19.620310] DVB: registering new adapter (Technotrend/Hauppauge WinTV
DVB-S rev1.3 SE)
[   19.661939] adapter has MAC addr = 00:d0:5c:00:00:b3
[   19.670459] dvb 0000:05:00.0: firmware: requesting
av7110/bootcode.bin
[   19.906050] dvb-ttpci: gpioirq unknown type=0 len=0
[   19.920105] dvb-ttpci: info @ card 0: firm f0240009, rtsl b0250018,
vid 00000000, app 80002622
[   19.920107] dvb-ttpci: firmware @ card 0 supports CI link layer
interface
[   20.096224] dvb-ttpci: adac type set to 0 @ card 0
[   20.101859] saa7146_vv: saa7146 (0): registered device video0 [v4l2]
[   20.101882] saa7146_vv: saa7146 (0): registered device vbi0 [v4l2]
[   20.289732] ves1x93: Detected ves1893a rev2
[   20.289737] DVB: registering adapter 0 frontend 0 (VLSI VES1x93
DVB-S)...
[   20.289865] input: DVB on-card IR receiver
as /devices/pci0000:00/0000:00:1e.0/0000:05:00.0/input/input6
[   20.289900] dvb-ttpci: found av7110-0.

A tuning attempt using dvbtune yields:

Quoted 1 line

dvbtune -f 12551000 -p v -s 22000

Using DVB card "VLSI VES1x93 DVB-S"
tuning DVB-S to L-Band:134513994, Pol:V Srate=22000000, 22kHz=off polling....
Getting frontend event
FE_STATUS:
polling....
Getting frontend event
FE_STATUS: FE_HAS_SIGNAL FE_HAS_LOCK FE_HAS_CARRIER FE_HAS_VITERBI FE_HAS_SYNC
Event: Frequency: 12551859

        SymbolRate: 22000000
        FEC_inner:  5

Bit error rate: 0
Signal strength: 43433
SNR: 57054
FE_STATUS: FE_HAS_SIGNAL FE_HAS_LOCK FE_HAS_CARRIER FE_HAS_VITERBI FE_HAS_SYNC

This is the output I get from 'scan' (dvbscan)

scanning /usr/share/dvb/dvb-s/Astra-19.2E
using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' initial transponder 12551500 V 22000000 5

Quoted 1 line
Quoted 1 line
Quoted 1 line

tune to: 12551:v:0:22000

DVB-S IF freq is 1951500
WARNING: filter timeout pid 0x0011
WARNING: filter timeout pid 0x0000
WARNING: filter timeout pid 0x0010
dumping lists (0 services)
Done.

Using a different card, I can tune, scan using the same command and receive a TS, so reception problems can be ruled out.

Any suggestions how to proceed to resolve the issue or what further data to provide to that end would be highly appreciated.

Best regards
Dietmar

_______________________________________________
linux-dvb users mailing list
For V4L/DVB development, please use instead [email protected] [email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb