cfi_flash: Fix problems with status/id read mode
PATCH 1/1 cfi_flash: Fix problems with status/id read mode
This patch adds some calls to set the flash chip in the read-status- register- or read-id-mode before the corresponding register is read back. This problem was detected while porting the common CFI driver to support the Xilinx DS617 flash chips.
--- drivers/mtd/cfi_flash.c | 12 ++++++++++++ 1 files changed, 12 insertions(+), 0 deletions(-)
drivers/mtd/cfi_flash.c +12 -0
@@ -1426,6 +1426,11 @@ int flash_real_protect (flash_info_t * info, long sector, int prot)#endif }; +/* +* Flash needs to be in status register read mode for +* flash_full_status_check() to work correctly +*/ +flash_write_cmd (info, sector,0 ,FLASH_CMD_READ_STATUS );if ((retcode =flash_full_status_check (info, sector, info->erase_blk_tout, prot ?"protect" :"unprotect" )) ==0 ) {
@@ -1973,6 +1978,13 @@ ulong flash_get_size (phys_addr_t base, int banknum, unsigned long max_size)case CFI_CMDSET_INTEL_PROG_REGIONS :case CFI_CMDSET_INTEL_EXTENDED :case CFI_CMDSET_INTEL_STANDARD : +/* +* Set flash to read-id mode. Otherwise +* reading protected status is not +* guaranteed. +*/ +flash_write_cmd (info, sect_cnt,0 , +FLASH_CMD_READ_ID ); info->protect[sect_cnt] = flash_isset (info, sect_cnt, FLASH_OFFSET_PROTECT,
Signature · 1 line
1.7.3.2
PATCH 1/1 cfi_flash: Fix problems with status/id read mode
Quoted 4 lines · On Monday 25 October 2010 18:31:29 Stefan Roese wrote:
This patch adds some calls to set the flash chip in the read-status- register- or read-id-mode before the corresponding register is read back. This problem was detected while porting the common CFI driver to support the Xilinx DS617 flash chips.
Applied to u-boot-cfi-flash/next. Thanks.
Cheers,
Stefan
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-0 Fax: (+49)-8142-66989-80 Email: office at denx.de