arm: am335x: DXR2: Move unconditional LAN9303 reset into command
PATCH 1/1 arm: am335x: DXR2: Move unconditional LAN9303 reset into command
The switch HW reset results in a disconnection of the switch port daisy- chain for a few seconds. This is not desired in the normal field use case. So lets remove this switch reset from the normal bootup sequence and move it into a board specific command. This way it can be executed in the development environment when really needed.
--- board/siemens/dxr2/board.c | 26 +++++++++++++++++++------- 1 file changed, 19 insertions(+), 7 deletions(-)
board/siemens/dxr2/board.c +19 -7
@@ -232,13 +232,6 @@ int board_eth_init(bd_t *bis)factoryset_setenv (); -/* Reset SMSC LAN9303 switch for default configuration */ -gpio_request (GPIO_LAN9303_NRST ,"nRST" ); -gpio_direction_output (GPIO_LAN9303_NRST ,0 ); -/* assert active low reset for 200us */ -udelay (200 ); -gpio_set_value (GPIO_LAN9303_NRST ,1 ); -/* Set rgmii mode and enable rmii clock to be sourced from chip */ writel ((RMII_MODE_ENABLE |RMII_CHIPCKL_ENABLE ), &cdev->miisel);
@@ -249,6 +242,25 @@ int board_eth_init(bd_t *bis) n += rv;return n; } + +static int do_switch_reset (cmd_tbl_t *cmdtp,int flag,int argc, +char *const argv[]) +{ +/* Reset SMSC LAN9303 switch for default configuration */ +gpio_request (GPIO_LAN9303_NRST ,"nRST" ); +gpio_direction_output (GPIO_LAN9303_NRST ,0 ); +/* assert active low reset for 200us */ +udelay (200 ); +gpio_set_value (GPIO_LAN9303_NRST ,1 ); + +return 0 ; +}; + +U_BOOT_CMD ( + switch_rst,CONFIG_SYS_MAXARGS ,1 , do_switch_reset, +"Reset LAN9303 switch via its reset pin" , +"" +);#endif /* #if defined(CONFIG_DRIVER_TI_CPSW) */ #endif /* #if (defined(CONFIG_DRIVER_TI_CPSW) && !defined(CONFIG_SPL_BUILD)) */
Signature · 1 line
1.8.5.5
Quoted 10 lines · Stefan Roese
The switch HW reset results in a disconnection of the switch port daisy- chain for a few seconds. This is not desired in the normal field use case. So lets remove this switch reset from the normal bootup sequence and move it into a board specific command. This way it can be executed in the development environment when really needed.
Signed-off-by Stefan Roese <[email protected]>Cc Roger Meier <[email protected]>Cc Lukas Stockmann <[email protected]>Cc Tom Rini <[email protected]>
Applied to u-boot-ti/master, thanks!
Signature · 8 lines
Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: <http://lists.denx.de/pipermail/u-boot/attachments/20140312/3ab6e566/attachment.pgp>