arm: socfpga: Enable saveenv for SD/MMC
PATCH v4 1/1 arm: socfpga: Enable saveenv for SD/MMC
From: Dinh Nguyen <[email protected]>
Enable the able to save the environment variables when SD/MMC is used.
Signed-off-by Dinh Nguyen <[email protected]>
---
v4: Move ENV_IS_NOWHERE to the mcvevk board config file
v3: Only define ENV_IS_NOWHERE if env is not in MMC, NAND, FAT, and SPI_FLASH
v2: Move this option to be on a per-board basis
Add config for socfpga_cyclone5 and socfpga_arria5
--- include/configs/socfpga_arria5_socdk.h | 4 ++++ include/configs/socfpga_common.h | 1 - include/configs/socfpga_cyclone5_socdk.h | 4 ++++ include/configs/socfpga_de0_nano_soc.h | 4 ++++ include/configs/socfpga_mcvevk.h | 2 ++ include/configs/socfpga_sockit.h | 4 ++++ 6 files changed, 18 insertions(+), 1 deletion(-)
include/configs/socfpga_arria5_socdk.h +4 -0
@@ -59,6 +59,10 @@#endif +#define CONFIG_ENV_IS_IN_MMC +#define CONFIG_SYS_MMC_ENV_DEV 0/* device 0 */ +#define CONFIG_ENV_OFFSET 512/* just after the MBR */ +/* USB */ #ifdef CONFIG_CMD_USB #define CONFIG_USB_DWC2_REG_ADDR SOCFPGA_USB1_ADDRESS
include/configs/socfpga_common.h +0 -1
@@ -281,7 +281,6 @@ unsigned int cm_get_qspi_controller_clk_hz(void);#define CONFIG_SYS_CONSOLE_IS_IN_ENV #define CONFIG_SYS_CONSOLE_OVERWRITE_ROUTINE #define CONFIG_SYS_CONSOLE_ENV_OVERWRITE -#define CONFIG_ENV_IS_NOWHERE #define CONFIG_ENV_SIZE 4096/*
include/configs/socfpga_cyclone5_socdk.h +4 -0
@@ -59,6 +59,10 @@#endif +#define CONFIG_ENV_IS_IN_MMC +#define CONFIG_SYS_MMC_ENV_DEV 0/* device 0 */ +#define CONFIG_ENV_OFFSET 512/* just after the MBR */ +/* USB */ #ifdef CONFIG_CMD_USB #define CONFIG_USB_DWC2_REG_ADDR SOCFPGA_USB1_ADDRESS
include/configs/socfpga_de0_nano_soc.h +4 -0
@@ -55,6 +55,10 @@#endif +#define CONFIG_ENV_IS_IN_MMC +#define CONFIG_SYS_MMC_ENV_DEV 0/* device 0 */ +#define CONFIG_ENV_OFFSET 512/* just after the MBR */ +/* USB */ #ifdef CONFIG_CMD_USB #define CONFIG_USB_DWC2_REG_ADDR SOCFPGA_USB1_ADDRESS
include/configs/socfpga_mcvevk.h +2 -0
@@ -43,6 +43,8 @@#define CONFIG_LOADADDR 0x01000000#define CONFIG_SYS_LOAD_ADDR CONFIG_LOADADDR +#define CONFIG_ENV_IS_NOWHERE +/* USB */ #ifdef CONFIG_CMD_USB #define CONFIG_USB_DWC2_REG_ADDR SOCFPGA_USB1_ADDRESS
include/configs/socfpga_sockit.h +4 -0
@@ -59,6 +59,10 @@#endif +#define CONFIG_ENV_IS_IN_MMC +#define CONFIG_SYS_MMC_ENV_DEV 0/* device 0 */ +#define CONFIG_ENV_OFFSET 512/* just after the MBR */ +/* USB */ #ifdef CONFIG_CMD_USB #define CONFIG_USB_DWC2_REG_ADDR SOCFPGA_USB1_ADDRESS
Signature · 1 line
2.4.5
Marek Vasut
AppliedPATCH v4 1/1 arm: socfpga: Enable saveenv for SD/MMC
Quoted 5 lines · dinguyen at opensource.altera.com
From: Dinh Nguyen <[email protected]>
Enable the able to save the environment variables when SD/MMC is used.
Signed-off-by Dinh Nguyen <[email protected]>
Applied, thanks!
Best regards,
Marek Vasut