Enable stmpe811 on stm32f429-disco board
Subsystems (2)
PATCH v2 1/1 Enable stmpe811 on stm32f429-disco board
This patchset has following one patchs changed in V2 based on V1
Changes in V2:
[Patch V2 3/4]: remove id, blocks, irq-trigger from dts node.
Changes in V1:
[Patch 1/4]: add I2C3 support on STM32F429 SoC [Patch 2/4]: Add pin map for I2C3 controller on stm32f4 [Patch 3/4]: enable stmpe811 on stm32429-disco board [Patch 4/4]; Fix stmpe811 get xyz data timeout issue
PATCH v2 1/4 ARM: dts: stm32: add I2C3 support on STM32F429 SoC
From: dillon min <[email protected]>
This patch adds I2C3 instances of the STM32F429 SoC
Signed-off-by dillon min <[email protected]>
--- arch/arm/boot/dts/stm32f429.dtsi | 12 ++++++++++++ 1 file changed, 12 insertions(+)
arch/arm/boot/dts/stm32f429.dtsi +12 -0
@@ -402,6 +402,18 @@ status = "disabled"; }; + i2c3: i2c@40005c00 { + compatible = "st,stm32f4-i2c"; + reg = <0x40005c00 0x400>; + interrupts = <72>, + <73>; + resets = <&rcc STM32F4_APB1_RESET(I2C3)>; + clocks = <&rcc 0 STM32F4_APB1_CLOCK(I2C3)>; + #address-cells = <1>; + #size-cells = <0>; + status = "disabled"; + }; + dac: dac@40007400 { compatible = "st,stm32f4-dac-core"; reg = <0x40007400 0x400>;
Signature · 1 line
2.7.4