Cross compile setup
Hi,
I am very interested that someone finally tries to do a native port
of
Linux for PA-RISC. At work I have an old HP 715/33 workstation (the
*one* machine that is not supported by mk-linux) which I would like
to
run linux on.
OSF has never managed to get the mach kernel booting on that box
and
my question about the problems were answered that is has something
to
do with the ethernet chip.
Some months ago I tried to cross-compile the mach-kernel under Linux-x86. For private purposes I have bought a SCSI-MOD-drive
which
serves as the data transfer media between my home PC running linux
and
the HP 715/33 at work.
I was not very successful with that cross-compiled mach-kernel.
After
booting the only messages I saw were from the secondary boot
loader:
OSF Mach boot
[/mach]: -a
text (0x11000) at 0x11000
data (0x92610) at 0x5
Then the machine stops with the LEDs 123568 on which means "HPMCdue
to Bus Error".
Unfortunately no one on the mklinux mailing list had any help for
that
problem (probably because the main developers were no longer
working
on/with mk-linux).
So my question here is the following:
Is the hppa-linux cross-compile setup for binutils and egcs possible from linux-x86 ?
If yes I would like to take part on the project as an "early
pre-alpha
stage"-tester :) in case you need one.
Ulrich
----------------------
Ulrich Strelow <[email protected] or
[email protected]>
Berlin, Germany
----------------------------------------------------------------------
To unsubscribe: send e-mail to [email protected] with `unsubscribe' as the subject.