Skip to contentSkip to conversation

[[email protected]: LUNA: Megaraid problems]

[email protected]: LUNA: Megaraid problems Matthew Fredrickson 3 participants 3 messages Mar 5, 2001 – Mar 6, 2001

lore
Share & tools
lore
#0 lore raw

I have a machine with a built-in Adaptec aic7xxx card and a Megaraid PCI card. My system (raid 5) boots off the Megaraid. For this to work I compiled the Megaraid module into the kernel while the aic7xxx loads as a module. dmesg shows the following:

megaraid: v107 (December 22, 1999)
megaraid: found 0x101e:0x9010:idx 0:bus 0:slot 14:func 0 scsi0 : Found a MegaRAID controller at 0x7810, IRQ: 10
megaraid: [UF80:1.61] detected 1 logical drives scsi0 : AMI MegaRAID UF80 254 commands 16 targs 3 chans 8 luns scsi : 1 host.
scsi0: scanning channel 1 for devices.
scsi0: scanning channel 2 for devices.
scsi0: scanning channel 3 for devices.
scsi0: scanning virtual channel for logical drives.
Vendor: MegaRAID Model: LD0 RAID5 34712R Rev: UF80
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 3, id 0, lun 0 scsi : detected 1 SCSI generic 1 SCSI disk total.

Works great with kernel 2.2.16. Worked great up to kernel 2.3.99-test8 or so. However under the current 2.4.x kernels (2.4.0, 2.4.1, 2.4.2) I get the following message:

scsi subsystem driver rev 1.0
megaraid: v107 (Dec 22, 1999)
megaraid: found 0x101e: 0x9010: in 00:0e.0
scsi0: found a megaraid controller at 0x7810, irq 10
megaraid: couldn't register I/O register requested_modules[scsi_hostadapter] root fs not found (repeat above 2 more time)
VFS - cannot open boot device 806 or 08:06

which makes sense - can't register device, can open device. The only difference I've been able to find between the working and non-working kernels is the "SCSI Subsystem Driver Rev 1.0" line.

So, what direction should I go? Anyone have any pointers?

Tia.

-- James

----

LUNA-LIST help:                  [email protected]
To unsubscribe:           [email protected]
To email the list keeper:                        [email protected] 
LUNA-LIST Web Site:   <URL:http://luna.huntsville.al.us/lunalist.htm>
#1 lore raw

Consider trying the megaraid driver megaraid.[ch] in 2.4.2-ac11 and above. It's v1.14g-ac.

Thanks,
Matt

Signature · 4 lines
Matt Domsch
Dell Linux Systems Group
Linux OS Development
www.dell.com/linux
#2 lore raw
In reply to Matthew Fredrickson
Quoted 3 lines

Works great with kernel 2.2.16. Worked great up to kernel 2.3.99-test8 or so. However under the current 2.4.x kernels (2.4.0, 2.4.1, 2.4.2) I get the following message:

Please test 2.4.2ac12. That has a much cleaned up megaraid.c 1.14g in it. I'd like feedback before handing it on to Linus. Im using it here on a kernel build disk with no problems