[[email protected]: LUNA: Megaraid problems]
I have a machine with a built-in Adaptec aic7xxx card and a Megaraid PCI card. My system (raid 5) boots off the Megaraid. For this to work I compiled the Megaraid module into the kernel while the aic7xxx loads as a module. dmesg shows the following:
megaraid: v107 (December 22, 1999)
megaraid: found 0x101e:0x9010:idx 0:bus 0:slot 14:func 0 scsi0 : Found a MegaRAID controller at 0x7810, IRQ: 10
megaraid: [UF80:1.61] detected 1 logical drives scsi0 : AMI MegaRAID UF80 254 commands 16 targs 3 chans 8 luns scsi : 1 host.
scsi0: scanning channel 1 for devices.
scsi0: scanning channel 2 for devices.
scsi0: scanning channel 3 for devices.
scsi0: scanning virtual channel for logical drives.
Vendor: MegaRAID Model: LD0 RAID5 34712R Rev: UF80
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 3, id 0, lun 0 scsi : detected 1 SCSI generic 1 SCSI disk total.
Works great with kernel 2.2.16. Worked great up to kernel 2.3.99-test8 or so. However under the current 2.4.x kernels (2.4.0, 2.4.1, 2.4.2) I get the following message:
scsi subsystem driver rev 1.0
megaraid: v107 (Dec 22, 1999)
megaraid: found 0x101e: 0x9010: in 00:0e.0
scsi0: found a megaraid controller at 0x7810, irq 10
megaraid: couldn't register I/O register requested_modules[scsi_hostadapter] root fs not found (repeat above 2 more time)
VFS - cannot open boot device 806 or 08:06
which makes sense - can't register device, can open device. The only difference I've been able to find between the working and non-working kernels is the "SCSI Subsystem Driver Rev 1.0" line.
So, what direction should I go? Anyone have any pointers?
Tia.
-- James
----
LUNA-LIST help: [email protected] To unsubscribe: [email protected] To email the list keeper: [email protected] LUNA-LIST Web Site: <URL:http://luna.huntsville.al.us/lunalist.htm>
Consider trying the megaraid driver megaraid.[ch] in 2.4.2-ac11 and above. It's v1.14g-ac.
Thanks,
Matt
Signature · 4 lines
Matt Domsch Dell Linux Systems Group Linux OS Development www.dell.com/linux
Quoted 3 lines
Works great with kernel 2.2.16. Worked great up to kernel 2.3.99-test8 or so. However under the current 2.4.x kernels (2.4.0, 2.4.1, 2.4.2) I get the following message:
Please test 2.4.2ac12. That has a much cleaned up megaraid.c 1.14g in it. I'd like feedback before handing it on to Linus. Im using it here on a kernel build disk with no problems