Skip to contentSkip to conversation

for 53c700 chip and NCR_D700 card against 2.4.4

NEW SCSI DRIVER [email protected] 3 participants 4 messages May 13, 2001 – May 14, 2001

lore
Share & tools
lore
#0 lore raw
Quoted 1 line

New SCSI driver for 53c700 chip

Good!

If I am not mistaken, Richard Hirst has also done work on this thing.

The Panther/lp486e/PWS/... has on-board ethernet (82596) and this now works under both 2.2 and 2.4.
It also has on-board SCSI (NCR 53c700-66), maybe memory mapped, I forget. Maybe nobody knows the addresses.
It would be somewhat interesting to get that thing to work as well.

Andries

#1 lore raw
Quoted 1 line

If I am not mistaken, Richard Hirst has also done work on this thing.

He did 53c710+. The 700 and 700/66 are much less capable devices.

According to http://www.murphy.nl/~ard/systems/pws/pws/node18.html
the NCR 53c700/66 is mapped at 0xCC0-0xCFF.

The system board id looks interesting too. I wonder if its related to the mac address.. Sadly my box is dead so I cant poke

#2 lore raw
In reply to [email protected]
Quoted 3 lines · Alan Cox
Quoted 1 line

If I am not mistaken, Richard Hirst has also done work on this thing.

He did 53c710+. The 700 and 700/66 are much less capable devices.

I did 53c700 as well, in the parisc-linux tree. Sounds like James' driver is more featureful than mine though.

Richard

#3 lore raw
Quoted 7 lines · Alan Cox
Quoted 3 lines
Quoted 1 line

If I am not mistaken, Richard Hirst has also done work on this thing.

He did 53c710+. The 700 and 700/66 are much less capable devices.

I did 53c700 as well, in the parisc-linux tree. Sounds like James' driver is more featureful than mine though.

I'll skip feeding the driver on to Linus until the two of you figure out the best path then