Problem with ACPI on Abit KT7,HPT370
Hi,
with all 2.4 kernels (latest I tried were 2.4.10 + 2.4.10-ac9), my Abit KT7-RAID with onboard HPT370 IDE RAID controller, BIOS version 4A, locks up when ACPI is enabled in the kernel. APM works fine. I enable
CONFIG_PM=YCONFIG_ACPI=YCONFIG_ACPI_BUSMGR=YCONFIG_ACPI_SYS=YCONFIG_ACPI_CPU=Y
The following messages could be useful:
this is the bootup messages when ACPI is disabled:
------------------------------------------------------------------------
Oct 8 19:50:31 pc1 kernel: HPT370: IDE controller on PCI bus 00 dev 98 Oct 8 19:50:31 pc1 kernel: PCI: Found IRQ 11 for device 00:13.0 Oct 8 19:50:31 pc1 kernel: HPT370: chipset revision 3 Oct 8 19:50:31 pc1 kernel: HPT370: not 100%% native mode: will probe irqs later Oct 8 19:50:31 pc1 kernel: ide2: BM-DMA at 0xec00-0xec07, BIOS settings: hde:DMA, hdf:pio Oct 8 19:50:31 pc1 kernel: ide3: BM-DMA at 0xec08-0xec0f, BIOS settings: hdg:pio, hdh:pio Oct 8 19:50:31 pc1 kernel: hda: IBM-DTTA-351010, ATA DISK drive Oct 8 19:50:31 pc1 kernel: hdc: SONY CD-RW CRX140E, ATAPI CD/DVD-ROM drive Oct 8 19:50:31 pc1 kernel: hde: IC35L040AVER07-0, ATA DISK drive
------------------------------------------------------------------------
When ACPI is enabled, it locks up after it detected "hdc: SONY CD-RW", the HDD access LED stays on and the system hangs until I do a hard reboot.
Contact me if you need further logs or reports.
Dominik Geisel
Signature · 4 lines
Women want mediocre men. And men are working hard to become as medicore as possible. GPG public key @ http://www.geisel.info/key.asc B216 156D 04EE AE0C 4C03 80C2 CE4B DBB3 801B 3CC2
Hi
with kernel 2.4.11-pre3-xfs + i2c CVS-patch + lmsensors it works fine on my system (Abit Bios KT7_49B0)
CONFIG_PM=yCONFIG_ACPI=yCONFIG_ACPI_DEBUG=yCONFIG_ACPI_BUSMGR=yCONFIG_ACPI_SYS=yCONFIG_ACPI_CPU=yCONFIG_ACPI_BUTTON=y
But i don't use ide cdrom's
I remember disabled sth in the bios ...but i have forget ... :(
regards dominik
Ps: "IC35L040AVER07-0" works in UDMA(44) or :( I have disabled the entry in the
blacklist of hpt366.c (dtla307030,dtla307060) for testing with the new
mb biosQuoted 43 lines
Hi,
with all 2.4 kernels (latest I tried were 2.4.10 + 2.4.10-ac9), my Abit KT7-RAID
with onboard HPT370 IDE RAID controller, BIOS version 4A, locks up when ACPI is enabled in the kernel. APM works fine. I enable
CONFIG_PM=YCONFIG_ACPI=YCONFIG_ACPI_BUSMGR=YCONFIG_ACPI_SYS=YCONFIG_ACPI_CPU=YThe following messages could be useful:
this is the bootup messages when ACPI is disabled:
------------------------------------------------------------------------Oct 8 19:50:31 pc1 kernel: HPT370: IDE controller on PCI bus 00 dev 98 Oct 8 19:50:31 pc1 kernel: PCI: Found IRQ 11 for device 00:13.0 Oct 8 19:50:31 pc1 kernel: HPT370: chipset revision 3 Oct 8 19:50:31 pc1 kernel: HPT370: not 100%% native mode: will probe irqs later Oct 8 19:50:31 pc1 kernel: ide2: BM-DMA at 0xec00-0xec07, BIOS settings: hde:DMA, hdf:pio Oct 8 19:50:31 pc1 kernel: ide3: BM-DMA at 0xec08-0xec0f, BIOS settings: hdg:pio, hdh:pio Oct 8 19:50:31 pc1 kernel: hda: IBM-DTTA-351010, ATA DISK drive Oct 8 19:50:31 pc1 kernel: hdc: SONY CD-RW CRX140E, ATAPI CD/DVD-ROM drive Oct 8 19:50:31 pc1 kernel: hde: IC35L040AVER07-0, ATA DISK drive------------------------------------------------------------------------
When ACPI is enabled, it locks up after it detected "hdc: SONY CD-RW", the HDD access LED stays on and the system hangs until I do a hard reboot.
Contact me if you need further logs or reports.
Dominik GeiselSignature · 5 lines
Women want mediocre men. And men are working hard to become as medicore as possible. GPG public key @ http://www.geisel.info/key.asc B216 156D 04EE AE0C 4C03 80C2 CE4B DBB3 801B 3CC2 -
Signature · 5 lines
---------------------------------- E-Mail: Dominik Thinay <[email protected]> Date: 08-Oct-2001 ----------------------------------
Quoted 2 lines · le lun 08-10-2001 at 20:10 Dominik Geisel a écrit :
When ACPI is enabled, it locks up after it detected "hdc: SONY CD-RW", the HDD access LED stays on and the system hangs until I do a hard reboot.
ABit VP6, HPT370, same problem here (lock before "hde...")
... plus: locks system on some IDE CDROM read errors, with or without ACPI.
Xav
I tried 2.4.10-ac10 with your config and played around with all possible BIOS settings...the problem persists.
Also, I am now quite sure it broke with BIOS version 3R.
Quoted 11 lines · Dominik Thinay
with kernel 2.4.11-pre3-xfs + i2c CVS-patch + lmsensors it works fine on my system (Abit Bios
KT7_49B0)CONFIG_PM=yCONFIG_ACPI=yCONFIG_ACPI_DEBUG=yCONFIG_ACPI_BUSMGR=yCONFIG_ACPI_SYS=yCONFIG_ACPI_CPU=yCONFIG_ACPI_BUTTON=yI remember disabled sth in the bios ...but i have forget ... :(