Skip to contentSkip to conversation

Problem with ACPI on Abit KT7,HPT370

DISCUSSION Dominik Geisel 3 participants 4 messages Oct 8, 2001 – Oct 9, 2001

lore
Share & tools
lore
#0 lore raw

Hi,

with all 2.4 kernels (latest I tried were 2.4.10 + 2.4.10-ac9), my Abit KT7-RAID with onboard HPT370 IDE RAID controller, BIOS version 4A, locks up when ACPI is enabled in the kernel. APM works fine. I enable

CONFIG_PM=Y
CONFIG_ACPI=Y
CONFIG_ACPI_BUSMGR=Y
CONFIG_ACPI_SYS=Y
CONFIG_ACPI_CPU=Y

The following messages could be useful:

this is the bootup messages when ACPI is disabled:
------------------------------------------------------------------------

Oct  8 19:50:31 pc1 kernel: HPT370: IDE controller on PCI bus 00 dev 98
Oct  8 19:50:31 pc1 kernel: PCI: Found IRQ 11 for device 00:13.0
Oct  8 19:50:31 pc1 kernel: HPT370: chipset revision 3
Oct  8 19:50:31 pc1 kernel: HPT370: not 100%% native mode: will probe irqs
later
Oct  8 19:50:31 pc1 kernel:     ide2: BM-DMA at 0xec00-0xec07,
BIOS settings: hde:DMA, hdf:pio
Oct  8 19:50:31 pc1 kernel:     ide3: BM-DMA at 0xec08-0xec0f, BIOS settings:
hdg:pio, hdh:pio
Oct  8 19:50:31 pc1 kernel: hda: IBM-DTTA-351010, ATA DISK drive
Oct  8 19:50:31 pc1 kernel: hdc: SONY CD-RW CRX140E, ATAPI CD/DVD-ROM drive
Oct  8 19:50:31 pc1 kernel: hde: IC35L040AVER07-0, ATA DISK drive

------------------------------------------------------------------------

When ACPI is enabled, it locks up after it detected "hdc: SONY CD-RW", the HDD access LED stays on and the system hangs until I do a hard reboot.

Contact me if you need further logs or reports.
Dominik Geisel

Signature · 4 lines
Women want mediocre men. And men are working hard to become as medicore
as possible.
GPG public key @ http://www.geisel.info/key.asc
B216 156D 04EE AE0C 4C03  80C2 CE4B DBB3 801B 3CC2
#1 lore raw

Hi
with kernel 2.4.11-pre3-xfs + i2c CVS-patch + lmsensors it works fine on my system (Abit Bios KT7_49B0)

CONFIG_PM=y
CONFIG_ACPI=y
CONFIG_ACPI_DEBUG=y
CONFIG_ACPI_BUSMGR=y
CONFIG_ACPI_SYS=y
CONFIG_ACPI_CPU=y
CONFIG_ACPI_BUTTON=y
But i don't use ide cdrom's

I remember disabled sth in the bios ...but i have forget ... :(

regards dominik

Ps: "IC35L040AVER07-0" works in UDMA(44) or :( I have disabled the entry in the

        blacklist of  hpt366.c (dtla307030,dtla307060) for testing with the new
        mb bios
Quoted 43 lines

Hi,

with all 2.4 kernels (latest I tried were 2.4.10 + 2.4.10-ac9), my Abit KT7-RAID
with onboard HPT370 IDE RAID controller, BIOS version 4A, locks up when ACPI is enabled in the kernel. APM works fine. I enable

CONFIG_PM=Y
CONFIG_ACPI=Y
CONFIG_ACPI_BUSMGR=Y
CONFIG_ACPI_SYS=Y
CONFIG_ACPI_CPU=Y

The following messages could be useful:

this is the bootup messages when ACPI is disabled:
------------------------------------------------------------------------

Oct  8 19:50:31 pc1 kernel: HPT370: IDE controller on PCI bus 00 dev 98
Oct  8 19:50:31 pc1 kernel: PCI: Found IRQ 11 for device 00:13.0
Oct  8 19:50:31 pc1 kernel: HPT370: chipset revision 3
Oct  8 19:50:31 pc1 kernel: HPT370: not 100%% native mode: will probe irqs
later
Oct  8 19:50:31 pc1 kernel:     ide2: BM-DMA at 0xec00-0xec07,
BIOS settings: hde:DMA, hdf:pio
Oct  8 19:50:31 pc1 kernel:     ide3: BM-DMA at 0xec08-0xec0f, BIOS settings:
hdg:pio, hdh:pio
Oct  8 19:50:31 pc1 kernel: hda: IBM-DTTA-351010, ATA DISK drive
Oct  8 19:50:31 pc1 kernel: hdc: SONY CD-RW CRX140E, ATAPI CD/DVD-ROM drive
Oct  8 19:50:31 pc1 kernel: hde: IC35L040AVER07-0, ATA DISK drive

------------------------------------------------------------------------

When ACPI is enabled, it locks up after it detected "hdc: SONY CD-RW", the HDD access LED stays on and the system hangs until I do a hard reboot.

Contact me if you need further logs or reports.
Dominik Geisel

Signature · 5 lines
Women want mediocre men. And men are working hard to become as medicore
as possible.
GPG public key @ http://www.geisel.info/key.asc
B216 156D 04EE AE0C 4C03  80C2 CE4B DBB3 801B 3CC2
-
Signature · 5 lines
----------------------------------
E-Mail: Dominik Thinay <[email protected]>
Date: 08-Oct-2001

----------------------------------
#2 lore raw
In reply to Dominik Geisel
Quoted 2 lines · le lun 08-10-2001 at 20:10 Dominik Geisel a écrit :

When ACPI is enabled, it locks up after it detected "hdc: SONY CD-RW", the HDD access LED stays on and the system hangs until I do a hard reboot.

ABit VP6, HPT370, same problem here (lock before "hde...")

... plus: locks system on some IDE CDROM read errors, with or without ACPI.

Xav

#3 lore raw
In reply to Dominik Geisel

I tried 2.4.10-ac10 with your config and played around with all possible BIOS settings...the problem persists.

Also, I am now quite sure it broke with BIOS version 3R.

Quoted 11 lines · Dominik Thinay

with kernel 2.4.11-pre3-xfs + i2c CVS-patch + lmsensors it works fine on my system (Abit Bios KT7_49B0)
CONFIG_PM=y
CONFIG_ACPI=y
CONFIG_ACPI_DEBUG=y
CONFIG_ACPI_BUSMGR=y
CONFIG_ACPI_SYS=y
CONFIG_ACPI_CPU=y
CONFIG_ACPI_BUTTON=y

I remember disabled sth in the bios ...but i have forget ... :(