Tuning Linux for high-speed disk subsystems
The heroinewarrior.com (Broadcast 2000) guys came to the following with the Tyan Thunder K7 (2 x 1.0 GHz Athlon MP) dual channel U160 (Adaptec) and RAID 0. http://heroinewarrior.com/athlon.php3
[-]
As for performance our experiences are biased because this system is almost
exclusively used for video software development not games like most. It needs a reliable operating system like Linux and very fast media storage drives.
The inverse telecine, a grueling memory excercise which takes 3 hours on a
dual PIII 933 and 2 hours on a dual Alpha, takes about 2 hours on the dual Athlon.
Our 100 Gig SCSI raid, consisting of 6 15,000 rpm drives on the motherboard's two SCSI 160 channels gives a full 110MB/sec read and write with RAID 0. With RAID chunks set to 1MB the write accesses go to 160MB/sec and read accesses go to 90MB/sec sustained. This system would make a good motion capture tool. Previous Intel attempts at onboard disk I/O would give 50MB/sec. [-]
-Dieter
Quoted 5 lines
Our 100 Gig SCSI raid, consisting of 6 15,000 rpm drives on the motherboard's two SCSI 160 channels gives a full 110MB/sec read and write with RAID 0. With RAID chunks set to 1MB the write accesses go to 160MB/sec and read accesses go to 90MB/sec sustained. This system would make a good motion capture tool. Previous Intel attempts at onboard disk I/O would give 50MB/sec.
How much do you think I can get out of 2x6 15k disks - each 6 disks are on their own SCSI-3/160 bus.
--
Roy Sigurd Karlsbakk, MCSE, MCNE, CLS, LCA
Computers are like air conditioners.
They stop working when you open Windows.
Am Freitag, 16. November 2001 12:51 schrieb Roy Sigurd Karlsbakk:
Quoted 9 lines
Quoted 6 lines
Our 100 Gig SCSI raid, consisting of 6 15,000 rpm drives on the motherboard's two SCSI 160 channels gives a full 110MB/sec read and write with RAID 0. With RAID chunks set to 1MB the write accesses go to 160MB/sec and read accesses go to 90MB/sec sustained. This system would make a good motion capture tool. Previous Intel attempts at onboard disk I/O would give 50MB/sec.
How much do you think I can get out of 2x6 15k disks - each 6 disks are on their own SCSI-3/160 bus.
As I count your disks may be the double for the best case. I read here on LKML a post that someone claims that W2k deliever 250 MB/s with such a configuration. Linux 2.4 should do the same. Ask the SCSI gurus.
Regards,
Dieter
Signature · 3 lines
Dieter Nützel Graduate Student, Computer Science @home: [email protected]