Skip to contentSkip to conversation

Tuning Linux for high-speed disk subsystems

DISCUSSION Dieter Nützel 2 participants 3 messages Nov 16, 2001

lore
Share & tools
lore
#0 lore raw

The heroinewarrior.com (Broadcast 2000) guys came to the following with the Tyan Thunder K7 (2 x 1.0 GHz Athlon MP) dual channel U160 (Adaptec) and RAID 0. http://heroinewarrior.com/athlon.php3

[-]
As for performance our experiences are biased because this system is almost
exclusively used for video software development not games like most. It needs a reliable operating system like Linux and very fast media storage drives.

The inverse telecine, a grueling memory excercise which takes 3 hours on a
dual PIII 933 and 2 hours on a dual Alpha, takes about 2 hours on the dual Athlon.

Our 100 Gig SCSI raid, consisting of 6 15,000 rpm drives on the motherboard's two SCSI 160 channels gives a full 110MB/sec read and write with RAID 0. With RAID chunks set to 1MB the write accesses go to 160MB/sec and read accesses go to 90MB/sec sustained. This system would make a good motion capture tool. Previous Intel attempts at onboard disk I/O would give 50MB/sec. [-]

-Dieter

#1 lore raw
Quoted 5 lines

Our 100 Gig SCSI raid, consisting of 6 15,000 rpm drives on the motherboard's two SCSI 160 channels gives a full 110MB/sec read and write with RAID 0. With RAID chunks set to 1MB the write accesses go to 160MB/sec and read accesses go to 90MB/sec sustained. This system would make a good motion capture tool. Previous Intel attempts at onboard disk I/O would give 50MB/sec.

How much do you think I can get out of 2x6 15k disks - each 6 disks are on their own SCSI-3/160 bus.
--
Roy Sigurd Karlsbakk, MCSE, MCNE, CLS, LCA

Computers are like air conditioners.
They stop working when you open Windows.

#2 lore raw

Am Freitag, 16. November 2001 12:51 schrieb Roy Sigurd Karlsbakk:

Quoted 9 lines
Quoted 6 lines

Our 100 Gig SCSI raid, consisting of 6 15,000 rpm drives on the motherboard's two SCSI 160 channels gives a full 110MB/sec read and write with RAID 0. With RAID chunks set to 1MB the write accesses go to 160MB/sec and read accesses go to 90MB/sec sustained. This system would make a good motion capture tool. Previous Intel attempts at onboard disk I/O would give 50MB/sec.

How much do you think I can get out of 2x6 15k disks - each 6 disks are on their own SCSI-3/160 bus.

As I count your disks may be the double for the best case. I read here on LKML a post that someone claims that W2k deliever 250 MB/s with such a configuration. Linux 2.4 should do the same. Ask the SCSI gurus.

Regards,
Dieter

Signature · 3 lines
Dieter Nützel
Graduate Student, Computer Science
@home: [email protected]