promise ultra 133 tx2 lets system standby during use...?
Quoted 11 lines · Thomas Munck Steenholdt
Quoted 2 lines
I've been having a lot of problems with my Ultra 133 TX2 controller, that if I boot my system a just doesn't touch it for a while, the
system
Quoted 3 lines
suspends to complete standby, even though the ext3 data is committed every 5 secs. causing disk activity and thus should disallow standby behaviour (at least that's the way it works on my onboard controller).
Lots of BIOSes are not bright enough to monitor a second IDE controller. You should be able to frob in the APM/ACPI bios and add its IRQ line to the monitor list
That would be in the BIOS right (or could it be done from linux) ?
Like i mentioned, my system is an IBM, which means tailored for users, which means that it(this particular system) won't let me add IRQ's to monitor, at least not from within the BIOS setup.
I can select to monitor "Hard Disks" "Serial Ports" that kind of granularity... But at least, what you are telling me, suggests to me that actually this is probably a problem in my BIOS rather than the kernel.
Would apm=off bypass this kind of thing?
-- Send gratis SMS og brug gratis e-mail på Everyday.com --
Quoted 1 line · Thomas Munck Steenholdt
That would be in the BIOS right (or could it be done from linux) ?
If you know the chipset and the docs are around then its actually normally very easy to poke from Linux too. Depends on the chipset
Quoted 1 line
Would apm=off bypass this kind of thing?
It may do yes