Skip to contentSkip to conversation

promise ultra 133 tx2 lets system standby during use...?

DISCUSSION Thomas Munck Steenholdt 2 participants 2 messages Aug 15, 2002

lore
Share & tools
lore
#0 lore raw
Quoted 11 lines · Thomas Munck Steenholdt
Quoted 2 lines

I've been having a lot of problems with my Ultra 133 TX2 controller, that if I boot my system a just doesn't touch it for a while, the

system

Quoted 3 lines

suspends to complete standby, even though the ext3 data is committed every 5 secs. causing disk activity and thus should disallow standby behaviour (at least that's the way it works on my onboard controller).

Lots of BIOSes are not bright enough to monitor a second IDE controller. You should be able to frob in the APM/ACPI bios and add its IRQ line to the monitor list

That would be in the BIOS right (or could it be done from linux) ?

Like i mentioned, my system is an IBM, which means tailored for users, which means that it(this particular system) won't let me add IRQ's to monitor, at least not from within the BIOS setup.
I can select to monitor "Hard Disks" "Serial Ports" that kind of granularity... But at least, what you are telling me, suggests to me that actually this is probably a problem in my BIOS rather than the kernel.

Would apm=off bypass this kind of thing?

-- Send gratis SMS og brug gratis e-mail på Everyday.com --

#1 lore raw
Quoted 1 line · Thomas Munck Steenholdt

That would be in the BIOS right (or could it be done from linux) ?

If you know the chipset and the docs are around then its actually normally very easy to poke from Linux too. Depends on the chipset

Quoted 1 line

Would apm=off bypass this kind of thing?

It may do yes