RAID1 problem, newbie to RAID
I am trying to get RAID1 working on a Debian machine with a 2.4.20 kernel. I hope I am close, but this is my first attempt at RAID on any platform.
I seem to get two out of three partitions. I think my problem is in that my "/" partition is mounted, but I'm new to RAID and I'm not sure how to fix this issue. Below is my: /proc/mdstat, raidtab, fdisk -l outputs. What am I missing here to solve my bungled configuration?
CM:~# cat /proc/mdstat
Personalities : [raid1]
read_ahead 1024 sectors
md0 : active raid1 hda1[0]
96256 blocks [2/1] [U_]md1 : active raid1 hda2[0]
9767424 blocks [2/1] [U_]
unused devices: <none>
CM:~# cat /etc/raidtab
raiddev /dev/md2
raid-level 1
nr-raid-disks 2
nr-spare-disks 0
chunk-size 32
persistent-superblock 1
device /dev/hda3
raid-disk 0
device /dev/hdc3
failed-disk 1raiddev /dev/md1
raid-level 1
nr-raid-disks 2
nr-spare-disks 0
chunk-size 32
persistent-superblock 1
device /dev/hda2
raid-disk 0
device /dev/hdc2
failed-disk 1raiddev /dev/md0
raid-level 1
nr-raid-disks 2
nr-spare-disks 0
chunk-size 32
persistent-superblock 1
device /dev/hda1
raid-disk 0
device /dev/hdc1
failed-disk 1CM:~# df -k Filesystem 1k-blocks Used Available Use% Mounted on /dev/hda3 86437648 480844 81565840 1% /
CM:~# fdisk -l
Disk /dev/hdc: 255 heads, 63 sectors, 12161 cylinders Units = cylinders of 16065 * 512 bytes
Device Boot Start End Blocks Id System /dev/hdc1 1 12 96358+ fd Linux raid autodetect /dev/hdc2 13 1228 9767520 fd Linux raid autodetect /dev/hdc3 1229 12161 87819322+ fd Linux raid autodetect
Disk /dev/hda: 255 heads, 63 sectors, 12161 cylinders Units = cylinders of 16065 * 512 bytes
Device Boot Start End Blocks Id System /dev/hda1 * 1 12 96358+ 83 Linux /dev/hda2 13 1228 9767520 82 Linux swap /dev/hda3 1229 12161 87819322+ 83 Linux
CM:~#
J Dalessandro on Mon 20/01 16:38 -0700:
Quoted 3 lines
I seem to get two out of three partitions. I think my problem is in that my "/" partition is mounted, but I'm new to RAID and I'm not sure how to fix this issue.
You can't have the filesystem mounted from the device you want to make RAID; you have to boot from something else to do it before mounting it.
Also please realize that when you use persistent-superblock 1, mkraid will use the last 4k (I think that's how much) for MD information, overwriting filesystem data there, so you have to resize2fs if you have existing data, before doing the mkraid. If you didn't do this, your FS is now hosed, but maybe you didn't have any data blocks there (after all, 4k is usually only one filesystem block) and e2fsck will repair it without data loss. Using debugfs and dumpe2fs will tell you more information.
Also, I'm curious why you have the failed disks in your raidtab.