Can't enable dma on /dev/hda
Hi!
I'm running a debian 3.0 System using kernel 2.4.19 (also tried 2.4.20). On this system it's not possible to enable dma on /dev/hda (HDD IDE)
The MoBo is a VIA Board called VIA-C3M266 (CLE266 chipset)
Northbridge: VT8623
Southbridge: VT8235
My kernel is compiled with this features:
ATAPI/IDE/MFM/RLL support --> IDE, ATA and ATAPI Block devices --> [*] generic PCI bus-master DMA support
[*] Use PCI DMA by default when available
[*] VIA82CXXX chipset support
And this is what hdparm tels me:
hdparm -d 1 /dev/hda:
/dev/hda:
setting using_dma to 1 (on)
HDIO_SET_DMA failed: Operation not permitted
using_dma = 0 (off)
What can I do to force my system to run using dma on /dev/hda. Or is my CLE266 chipset a bit too new for being supported by 2.4.19/20?
Hope somebody is able to help me
maxxle
Quoted 8 lines · maxxle
Hi!
I'm running a debian 3.0 System using kernel 2.4.19 (also tried 2.4.20). On this system it's not possible to enable dma on
/dev/hda(HDD IDE)The MoBo is a VIA Board called VIA-C3M266 (CLE266 chipset)
Northbridge: VT8623
Southbridge: VT8235
You need 2.4.21pre for the 8235
I suppose that your chip is not supported by kernel. :-(
Kernel support only 82C*** chips... as you see, it's not your chip. i have VT82C598 bridge, and dma is available on my system.
Agri
---------- Original Message -----------
From: [email protected] (maxxle)
To: [email protected]
Sent: 11 Feb 2003 19:31:16 +0000
Subject: Can't enable dma on /dev/hda
Quoted 29 lines
Hi!
I'm running a debian 3.0 System using kernel 2.4.19 (also tried 2.4.20). On this system it's not possible to enable dma on
/dev/hda(HDD IDE)The MoBo is a VIA Board called VIA-C3M266 (CLE266 chipset)
Northbridge: VT8623
Southbridge: VT8235My kernel is compiled with this features:
ATAPI/IDE/MFM/RLL support --> IDE, ATA and ATAPI Block devices --> [*] generic PCI bus-master DMA support
[*] Use PCI DMA by default when available
[*] VIA82CXXX chipset supportAnd this is what hdparm tels me:
hdparm -d 1/dev/hda:
/dev/hda:
settingusing_dmato 1 (on)
HDIO_SET_DMAfailed: Operation not permitted
using_dma= 0 (off)What can I do to force my system to run using dma on
/dev/hda. Or is my CLE266 chipset a bit too new for being supported by 2.4.19/20?Hope somebody is able to help me
Quoted 7 lines
maxxle
-
To unsubscribe from this list: send the line "unsubscribe linux- kernel" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
------- End of Original Message -------