Skip to contentSkip to conversation

Terratec Aureon Space

DISCUSSION Zébulon (by way of Zébulon <>) 3 participants 3 messages May 17, 2003 – May 19, 2003

lore
Share & tools
lore
#0 lore raw
Quoted 5 lines

only if we get enough technical information...

at least we need to know the wire connection between codec and ice1724 chips, especially 61, 62 and 63 pins of Wolfson chip and GPIO pins of ice1724 chip.

Would it be possible to find it by analysing the circuits on the card itself
?

Eric

-------------------------------------------------------
This SF.net email is sponsored by: If flattening out C++ or Java code to make your application fit in a relational database is painful, don't do it! Check out ObjectStore. Now part of Progress Software.
http://www.objectstore.net/sourceforge

#1 lore raw

At Sat, 17 May 2003 08:31:12 +0200,

Quoted 9 lines · Z╴bulon
Quoted 6 lines

only if we get enough technical information...

at least we need to know the wire connection between codec and ice1724 chips, especially 61, 62 and 63 pins of Wolfson chip and GPIO pins of ice1724 chip.

Would it be possible to find it by analysing the circuits on the card itself
?

yes, if the wiring is flat. but you'll need a louped :)

Takashi

-------------------------------------------------------
This SF.net email is sponsored by: If flattening out C++ or Java code to make your application fit in a relational database is painful, don't do it! Check out ObjectStore. Now part of Progress Software.
http://www.objectstore.net/sourceforge

#2 lore raw
In reply to Zébulon (by way of Zébulon <>)
Quoted 12 lines · Ze'bulon (by way of Ze'bulon <>) wrote:
Quoted 7 lines

only if we get enough technical information...

at least we need to know the wire connection between codec and ice1724 chips, especially 61, 62 and 63 pins of Wolfson chip and GPIO pins of ice1724 chip.

Would it be possible to find it by analysing the circuits on the card itself ?

Chances are that this is possible. I did it for the maxistudio isis. You'll need a multimeter with a beep function and some common sense knowledge of which connections are most likely.
Most PCI cards are 4 layer PCB's with power and ground distribution on the inner layer. This means that the signal traces are on the outside of the board, so you can use a magnifying glass to trace them. Using a digital camera with proper lighting works even better. You make a picture of the piece of board you want to analyze (of both sides of course), with a good resolution. This gives you a more 'stable' view of the traces.

Pieter

-------------------------------------------------------
This SF.net email is sponsored by: ObjectStore.
If flattening out C++ or Java code to make your application fit in a relational database is painful, don't do it! Check out ObjectStore. Now part of Progress Software. http://www.objectstore.net/sourceforge