DINK32 R13.1 on Sandpoint X2
Hi,all,
Now I'm working on a Motorola Sandpoint X2 board with ppc8240.
I use DINK32 r13.1 to boot my linux kernel image.
From DINK32 r13.1 user manual,I know that DINK32 r13.1 supports
ethernet card Realtek 8139,but after these steps:
DINK32[MPC8240] {7} >>ni -i
some configrations......
DINK32[MPC7455] {8} >>ni
NETWORK INFORMATION
PCI CARD
Type 8139/10EC on slot 16
SETTINGS
SERVER(TFTP) : 10. 18.15.27
GATEWAY : 10. 18.15.254
NETMASK : 255.255.255. 0
DHCP : 0. 0. 0. 0
CLIENT(DINK) : 10. 18.15.201
DHCP: Disabled
SESSION TIMEOUT: Never Then I reset the system,but the Tealtek 8139 seems not to work correctly!:( I ping the board from my host computer with OS Redhat linux 9.0,but I can't get any response!
Can anyone help me?
����������������Yuxiao Xi
����������������[email protected]
��������������������2003-09-02
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
Quoted 6 lines · Yuxiao Xi
Hi,all,
Now I'm working on a Motorola Sandpoint X2 board with ppc8240.
I use DINK32 r13.1 to boot my linux kernel image.
From DINK32 r13.1 user manual,I know that DINK32 r13.1 supports
ethernet card Realtek 8139,but after these steps:
What I would suggest is that instead of using the ethernet card support, you use the serial support still. DINK32 r13.0.0 and newer support 115200 baud, so loading a kernel via serial is now much less painful than it used to be.
--
Tom Rini
http://gate.crashing.org/~trini/
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/