Skip to contentSkip to conversation

Sk98Lin driver

DISCUSSION Lukas Hejtmanek 2 participants 3 messages Jun 6, 2005

lore
Share & tools
lore
#0 lore raw

Hello,

does someone have some experiences with this card? I'm using 8.16 or 8.18 driver (I do not want 6.x driver as it does not support suspend/resume). Basically it works but on UDP I get about 50 % packet loss when I try to receive 1Gbps. It's reported as frame and overruns.

Does someone have similar observation?

Signature · 1 line
Lukáš Hejtmánek
#1 lore raw
Quoted 8 lines · Lukas Hejtmanek

Hello,

does someone have some experiences with this card? I'm using 8.16 or 8.18 driver (I do not want 6.x driver as it does not support suspend/resume). Basically it works but on UDP I get about 50 % packet loss when I try to receive 1Gbps. It's reported as frame and overruns.

Does someone have similar observation?

Can you give the skge driver that obsoletes sk98lin in -mm?

(insert rant here why it's still not in mainline)

#2 lore raw
Quoted 3 lines · Christoph Hellwig

Can you give the skge driver that obsoletes sk98lin in -mm?

(insert rant here why it's still not in mainline)

Slightly better but still not good enough.

Using my testing application it reports about 10 errors/sec (frame).

Using iperf:
iperf -s -u -w 16m
------------------------------------------------------------
Server listening on UDP port 5001
Receiving 1470 byte datagrams
UDP buffer size: 16.0 MByte
------------------------------------------------------------

[  5] local 147.251.54.96 port 5001 connected with 147.251.54.34 port 32915
[  5]  0.0-10.3 sec    614 MBytes    502 Mbits/sec  15.220 ms 376630/814324 (46%)
[  5]  0.0-10.3 sec  1 datagrams received out-of-order

it is 46% packet loss but no errors on interface.

(peer is dual opteron box, my box is Pentium-M 1.6GHz, 512MB RAM).

Sending to peer using iperf:
iperf -s -u -w 16m
------------------------------------------------------------
Server listening on UDP port 5001
Receiving 1470 byte datagrams
UDP buffer size: 16.0 MByte
------------------------------------------------------------

[  3] local 147.251.54.34 port 5001 connected with 147.251.54.96 port 1024
[  3]  0.0-10.0 sec    836 MBytes    700 Mbits/sec  0.013 ms 290722/886955 (33%)
[  3]  0.0-10.0 sec  1 datagrams received out-of-order

This second case is a lot better than original driver from syskonnect which flooded outgoing interface at rate 500Mbps and no more packets were transmitted.

Boxes are interconnected using GE switch which can handle about 920Mbps between two dual operon boxes.

Signature · 1 line
Lukáš Hejtmánek