Sk98Lin driver
Hello,
does someone have some experiences with this card? I'm using 8.16 or 8.18 driver (I do not want 6.x driver as it does not support suspend/resume). Basically it works but on UDP I get about 50 % packet loss when I try to receive 1Gbps. It's reported as frame and overruns.
Does someone have similar observation?
Signature · 1 line
Lukáš Hejtmánek
Quoted 8 lines · Lukas Hejtmanek
Hello,
does someone have some experiences with this card? I'm using 8.16 or 8.18 driver (I do not want 6.x driver as it does not support suspend/resume). Basically it works but on UDP I get about 50 % packet loss when I try to receive 1Gbps. It's reported as frame and overruns.
Does someone have similar observation?
Can you give the skge driver that obsoletes sk98lin in -mm?
(insert rant here why it's still not in mainline)
Quoted 3 lines · Christoph Hellwig
Can you give the skge driver that obsoletes sk98lin in -mm?
(insert rant here why it's still not in mainline)
Slightly better but still not good enough.
Using my testing application it reports about 10 errors/sec (frame).
Using iperf:
iperf -s -u -w 16m
------------------------------------------------------------
Server listening on UDP port 5001
Receiving 1470 byte datagrams
UDP buffer size: 16.0 MByte
------------------------------------------------------------
[ 5] local 147.251.54.96 port 5001 connected with 147.251.54.34 port 32915 [ 5] 0.0-10.3 sec 614 MBytes 502 Mbits/sec 15.220 ms 376630/814324 (46%) [ 5] 0.0-10.3 sec 1 datagrams received out-of-order
it is 46% packet loss but no errors on interface.
(peer is dual opteron box, my box is Pentium-M 1.6GHz, 512MB RAM).
Sending to peer using iperf:
iperf -s -u -w 16m
------------------------------------------------------------
Server listening on UDP port 5001
Receiving 1470 byte datagrams
UDP buffer size: 16.0 MByte
------------------------------------------------------------
[ 3] local 147.251.54.34 port 5001 connected with 147.251.54.96 port 1024 [ 3] 0.0-10.0 sec 836 MBytes 700 Mbits/sec 0.013 ms 290722/886955 (33%) [ 3] 0.0-10.0 sec 1 datagrams received out-of-order
This second case is a lot better than original driver from syskonnect which flooded outgoing interface at rate 500Mbps and no more packets were transmitted.
Boxes are interconnected using GE switch which can handle about 920Mbps between two dual operon boxes.
Signature · 1 line
Lukáš Hejtmánek