i386: put HOTPLUG_CPU under Processor type, not Bus options
PATCH 1/1 i386: put HOTPLUG_CPU under Processor type, not Bus options
From: Randy Dunlap <[email protected]>
Move the HOTPLUG_CPU option under "Processor type" instead of under "Bus options". This makes it the same for i386 as most other processor types (arm, ia64, parisc, ppc, s390, & x86_64; but not for powerpc). Besides, it takes me too long to find it under Bus options. I can't be the only person who has trouble finding it.
Signed-off-by Randy Dunlap <[email protected]>
--- arch/i386/Kconfig | 19 ++++++++++--------- 1 files changed, 10 insertions(+), 9 deletions(-)
arch/i386/Kconfig +10 -9
@@ -680,6 +680,16 @@ config CRASH_DUMP depends on HIGHMEM help Generate crash dump after being started by kexec. + +config HOTPLUG_CPU + bool "Support for hot-pluggable CPUs (EXPERIMENTAL)" + depends on SMP && HOTPLUG && EXPERIMENTAL + ---help--- + Say Y here to experiment with turning CPUs off and on. CPUs + can be controlled through /sys/devices/system/cpu. + + Say N. + endmenu
@@ -966,15 +976,6 @@ config SCx200 This support is also available as a module. If compiled as a module, it will be called scx200. -config HOTPLUG_CPU - bool "Support for hot-pluggable CPUs (EXPERIMENTAL)" - depends on SMP && HOTPLUG && EXPERIMENTAL - ---help--- - Say Y here to experiment with turning CPUs off and on. CPUs - can be controlled through /sys/devices/system/cpu. - - Say N. - source "drivers/pcmcia/Kconfig" source "drivers/pci/hotplug/Kconfig"
---