Skip to contentSkip to conversation

i386: put HOTPLUG_CPU under Processor type, not Bus options

PATCH New Randy.Dunlap 1 participant 1 message Jan 10, 2006

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 i386: put HOTPLUG_CPU under Processor type, not Bus options

From: Randy Dunlap <[email protected]>

Move the HOTPLUG_CPU option under "Processor type" instead of under "Bus options". This makes it the same for i386 as most other processor types (arm, ia64, parisc, ppc, s390, & x86_64; but not for powerpc). Besides, it takes me too long to find it under Bus options. I can't be the only person who has trouble finding it.

---
 arch/i386/Kconfig |   19 ++++++++++---------
 1 files changed, 10 insertions(+), 9 deletions(-)
arch/i386/Kconfig +10 -9
@@ -680,6 +680,16 @@ config CRASH_DUMP
 	depends on HIGHMEM
 	help
 	  Generate crash dump after being started by kexec.
+
+config HOTPLUG_CPU
+	bool "Support for hot-pluggable CPUs (EXPERIMENTAL)"
+	depends on SMP && HOTPLUG && EXPERIMENTAL
+	---help---
+	  Say Y here to experiment with turning CPUs off and on.  CPUs
+	  can be controlled through /sys/devices/system/cpu.
+
+	  Say N.
+
 endmenu
 
 
@@ -966,15 +976,6 @@ config SCx200
 	  This support is also available as a module.  If compiled as a
 	  module, it will be called scx200.
 
-config HOTPLUG_CPU
-	bool "Support for hot-pluggable CPUs (EXPERIMENTAL)"
-	depends on SMP && HOTPLUG && EXPERIMENTAL
-	---help---
-	  Say Y here to experiment with turning CPUs off and on.  CPUs
-	  can be controlled through /sys/devices/system/cpu.
-
-	  Say N.
-
 source "drivers/pcmcia/Kconfig"
 
 source "drivers/pci/hotplug/Kconfig"

---