Skip to contentSkip to conversation

New: SATA problem on sata_nv (NFPIK8AA-8EKRS)

Bugme-new Andrew Morton 1 participant 1 message Feb 11, 2006 ACPI

lore
Share & tools
lore
#0 lore raw

This might be an ACPI problem?

Begin forwarded message:

Date: Sat, 11 Feb 2006 08:00:00 -0800
From: [email protected]
To: [email protected]
Subject: [Bugme-new] [Bug 6056] New: SATA problem on sata_nv (NFPIK8AA-8EKRS)

http://bugzilla.kernel.org/show_bug.cgi?id=6056

Summary: SATA problem on sata_nv (NFPIK8AA-8EKRS)
Kernel Version: 2.6.15.4
Status: NEW
Severity: high
Owner: [email protected]
Submitter: [email protected]

Most recent kernel where this bug did not occur:

Distribution:
FedoraCore4(x86-64)

Hardware Environment:
CPU: Opteron 140EE
Motherboard: NFPIK8AA-8EKRS
Memory: 512MB x 2 (ECC-Reg. DDR400)
HDD:HDS728080PLA380.

Software Environment:
Problem Description:

I have begun to use a PC with a Motherboard named NFPIK8AA-8EKRS.
http://www.foxconnchannel.com/products_motherboard_2.cfm?pName=NFPIK8AA-8EKRS

The Board has two on-board SATA controllers,
one is called Nforce4 Professional 2200(CK8-04)
other is called Nforce4 professional 2050(I/O-4).
And each controller has four SATA ports.
Thus this board has total 8 SATA ports.

I find when a SATA Disk which FC4 is installed is connected to a SATA ports controlled by I/O-4, the disk is not boot without the option of "acpi=noirq". When the Disk is connected to CK8-04,
Boot process works fine.

I have took pictures of monitor
showing error message in booting without "acpi=noirq".
http://type-r.dnsalias.net/9usjs/a.jpg
http://type-r.dnsalias.net/9usjs/b.jpg
http://type-r.dnsalias.net/9usjs/c.jpg
http://type-r.dnsalias.net/9usjs/d.jpg
http://type-r.dnsalias.net/9usjs/e.jpg

I also put dmesg's
http://type-r.dnsalias.net/9usjs/dmesg.txt
http://type-r.dnsalias.net/9usjs/dmesg_noirq.txt.

Former shows the log when I connect the HDD to the port controlled by CK8-04, latter shows one when I connect the HDD to the port controlled by I/O-4.

If further information is needed,
I will post it as much as possible.

Steps to reproduce:
1. Power off the PC
2. Connect the SATA disk to ports controlled by I/O-4.
3. Power on the PC

------- You are receiving this mail because: -------
You are on the CC list for the bug, or are watching someone who is.