MPC875 & FEC Ethernet
Hello
I can use the u-boot command interpreter on my MPC875 board. FEC1 is responsible for ethernet. So i set in my board config file:
#define CONFIG_ETHER_ON_FEC1
#define CONFIG_FEC_ENET
#ifdef CONFIG_FEC_ENET
#define CF_DISCOVER_PHY
#define FEC_ENET
#endif
when i call "ping target", i get the message "TX timeout". According the the debug output FEC1 just doesn't fetch data from the TX buffer, though ECNTRL and X_DES_ACTIVE set correctly. Any ideas how to solve this ?
big thanks
josef
Quoted 4 lines · In message <20060216170941.GA2262@false> you wrote:
when i call "ping target", i get the message "TX timeout". According the the debug output FEC1 just doesn't fetch data from the TX buffer, though ECNTRL and
X_DES_ACTIVEset correctly. Any ideas how to solve this ?
Check your clocks / clock routing / pin configuration.
Best regards,
Wolfgang Denk
Signature · 5 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de HEALTH WARNING: Care Should Be Taken When Lifting This Product, Since Its Mass, and Thus Its Weight, Is Dependent on Its Velocity Relative to the User.