Skip to contentSkip to conversation

MPC875 & FEC Ethernet

U-Boot-Users Josef Angermeier 2 participants 2 messages Feb 16, 2006 – Feb 17, 2006

lore
Share & tools
lore
#0 lore raw

Hello

I can use the u-boot command interpreter on my MPC875 board. FEC1 is responsible for ethernet. So i set in my board config file:

#define CONFIG_ETHER_ON_FEC1
#define CONFIG_FEC_ENET
#ifdef CONFIG_FEC_ENET
#define CF_DISCOVER_PHY
#define FEC_ENET
#endif

when i call "ping target", i get the message "TX timeout". According the the debug output FEC1 just doesn't fetch data from the TX buffer, though ECNTRL and X_DES_ACTIVE set correctly. Any ideas how to solve this ?

big thanks

josef

#1 lore raw
Quoted 4 lines · In message <20060216170941.GA2262@false> you wrote:

when i call "ping target", i get the message "TX timeout". According the the debug output FEC1 just doesn't fetch data from the TX buffer, though ECNTRL and X_DES_ACTIVE set correctly. Any ideas how to solve this ?

Check your clocks / clock routing / pin configuration.

Best regards,

Wolfgang Denk

Signature · 5 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
HEALTH WARNING: Care Should Be Taken When Lifting This Product, Since
Its Mass, and Thus Its Weight, Is Dependent on Its Velocity  Relative
to the User.