Skip to contentSkip to conversation

Fast flashing with MPCBDM

U-Boot-Users Thomas Stark 2 participants 2 messages Feb 20, 2006

lore
Share & tools
lore
#0 lore raw

Hello U-Boot users,

when i write an uboot image to my flash with ppc-linux-gdb (with a MPCBDM cable), i get from time to time the following message:
---Type <return> to continue, or q <return> to quit---

This is pretty annoying when you have to flash very often.

Can anybody please tell me how to get rid of this?

Thanks in advance.

Greetings,
Thomas

#1 lore raw
Quoted 4 lines · In message <[email protected]> you wrote:

when i write an uboot image to my flash with ppc-linux-gdb (with a MPCBDM cable), i get from time to time the following message:
---Type <return> to continue, or q <return> to quit---

...

Quoted 1 line

Can anybody please tell me how to get rid of this?

I take it that it may be a two-pass sort of solution. In the first pass, RTFM.

Then open your GDB manual, and try if you  can  find  something  that
might  be  related  to  Controlling  GDB,  and  if there is something

written about the Screen size or so.

Write down each step it took you to get the wanted information, so that you can repeat the procedure in case similar propblems come up later.

Please also note that your posting is not related to U-Boot and thus off topic here.

Hope this helps.

Best regards,

Wolfgang Denk

Signature · 4 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
The ultimate barrier is one's viewpoint.
                        - Terry Pratchett, _The Dark Side of the Sun_