Marvell DB64460-BP I2C_BOOT/Swap_BOOT Issue
Hi all,
I tried booting the target with I2C_BOOT disabled and failed - No any serial output. Then I programmed the same image on the Large Flash area 0xf4f00000 and inserted JP46 to swap 8-bit Boot Source to 32-bit Boot Source. I got the following output:
U-Boot 1.1.3 (Mar 16 2006 - 09:12:14)--Marvell DB64460 (1.0)
CPU: MPC7447A v1.1 @ 1396.500 MHz BOARD: DB64460 DRAM: SPD Checksum ok!
-- DIMM1 has 1 banks
-- DIMM2 has 0 banks
ECC Initialization of Bank 0: PASS
CAS Latency = 2.5 tRP = 3 tRAS = 6 tRCD=3 *** ONLY the first 256MB DRAM memory are used out of the 512MB
Sure, I did some changes on CPU type detection and clock setting only to make it work with I2C_BOOT enabled.
Questions:
1. How to make I2C_BOOT disable case work? If would better with 8-bit default boot FLASH.
2. Anyone tried booting Swap BOOT successful on this board?
TIA,
Sam
___________________________________________________________
??????????????????????????
http://cn.photos.yahoo.com