Skip to contentSkip to conversation

Marvell DB64460-BP I2C_BOOT/Swap_BOOT Issue

U-Boot-Users Sam Song 1 participant 1 message Mar 16, 2006

lore
Share & tools
lore

Sam Song

author
#0 lore raw

Hi all,

I tried booting the target with I2C_BOOT disabled and failed - No any serial output. Then I programmed the same image on the Large Flash area 0xf4f00000 and inserted JP46 to swap 8-bit Boot Source to 32-bit Boot Source. I got the following output:

U-Boot 1.1.3 (Mar 16 2006 - 09:12:14)--Marvell DB64460 (1.0)

CPU:   MPC7447A v1.1 @ 1396.500 MHz
BOARD: DB64460
DRAM:  SPD Checksum ok!

-- DIMM1 has 1 banks
-- DIMM2 has 0 banks
ECC Initialization of Bank 0: PASS
CAS Latency = 2.5 tRP = 3 tRAS = 6 tRCD=3 *** ONLY the first 256MB DRAM memory are used out of the 512MB

Sure, I did some changes on CPU type detection and clock setting only to make it work with I2C_BOOT enabled.

Questions:
1. How to make I2C_BOOT disable case work? If would better with 8-bit default boot FLASH.
2. Anyone tried booting Swap BOOT successful on this board?

TIA,

Sam

___________________________________________________________
??????????????????????????
http://cn.photos.yahoo.com