Skip to contentSkip to conversation

unable to mount root

U-Boot-Users Wolfgang Denk 2 participants 3 messages Jun 25, 2006 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 5 lines · In message <[email protected]> you wrote:

my uboot is in the nand flash,and i don't know how to mount the root
file system.
what's the difference between ramdisk and mtd device? and if i am going to use the mtd device how can i make the root file system ?

All these are very basic questionsch have nothing to do with U-Boot. I recommend to read some books about Linux in general and embedded Linux, like Karim Yaghmour's "Building Embedded Linux Systems" and/or Craig Hollabaugh's "Embedded Linux: Hardware, Software, and Inter- facing"; also, the DULG has some useful information, see
http://www.denx.de/wiki/DULG/Manual

Best regards,

Wolfgang Denk

Signature · 3 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Old programmers never die, they just become managers.
#2 lore raw

[U-Boot-Users] new to u-boot

Hi,
I am new to u-boot. I have read the documentation provided. I am creating my new config file for our board.
Have a question on the functions I need to provide in this config file.
I see that most of the files have the following
functions: initdram(..), checkboard(..).
But in some config files in board/xxxx directory, I saw that there are more functions provided in this file and each board has different functions. How do these functions get called by the u-boot main code. Do I need to make changes to the u-boot main code also so as to call these functions in my config file in /board/xxx directory.
Thanks for help.

Srini

__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com

#3 lore raw

[U-Boot-Users] new to u-boot

Quoted 4 lines · In message <[email protected]> you wrote:

But in some config files in board/xxxx directory, I saw that there are more functions provided in this file and each board has different functions.

Each board has different features and a different hardware design; this results in different code to support these features.

Quoted 2 lines

How do these functions get called by the u-boot main code. Do I need to make changes to the u-boot main

See the init fuction calling sequence in board.c

Quoted 2 lines

code also so as to call these functions in my config file in /board/xxx directory.

Normally no changes to common code should be necessary.

Best regards,

Wolfgang Denk

Signature · 4 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"Unix is simple, but it takes a genius to understand the simplicity."
					             - Dennis Ritchie