unable to mount root
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 5 lines · In message <[email protected]> you wrote:
my uboot is in the nand flash,and i don't know how to mount the root
file system.
what's the difference between ramdisk and mtd device? and if i am going to use the mtd device how can i make the root file system ?
All these are very basic questionsch have nothing to do with U-Boot. I recommend to read some books about Linux in general and embedded Linux, like Karim Yaghmour's "Building Embedded Linux Systems" and/or Craig Hollabaugh's "Embedded Linux: Hardware, Software, and Inter- facing"; also, the DULG has some useful information, see
http://www.denx.de/wiki/DULG/Manual
Best regards,
Wolfgang Denk
Signature · 3 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de Old programmers never die, they just become managers.
[U-Boot-Users] new to u-boot
Hi,
I am new to u-boot. I have read the documentation provided. I am creating my new config file for our board.
Have a question on the functions I need to provide in this config file.
I see that most of the files have the following
functions: initdram(..), checkboard(..).
But in some config files in board/xxxx directory, I saw that there are more functions provided in this file and each board has different functions. How do these functions get called by the u-boot main code. Do I need to make changes to the u-boot main code also so as to call these functions in my config file in /board/xxx directory.
Thanks for help.
Srini
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
[U-Boot-Users] new to u-boot
Quoted 4 lines · In message <[email protected]> you wrote:
But in some config files in board/xxxx directory, I saw that there are more functions provided in this file and each board has different functions.
Each board has different features and a different hardware design; this results in different code to support these features.
Quoted 2 lines
How do these functions get called by the u-boot main code. Do I need to make changes to the u-boot main
See the init fuction calling sequence in board.c
Quoted 2 lines
code also so as to call these functions in my config file in /board/xxx directory.
Normally no changes to common code should be necessary.
Best regards,
Wolfgang Denk
Signature · 4 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de "Unix is simple, but it takes a genius to understand the simplicity." - Dennis Ritchie