Regarding MPC8280 boot
Hai All
We have a MPC8280 custom board and we are using u-boot-1.1.6 and successfully booting u-boot.
Now we are trying to compile linux 2.6.14 source available are www.denx.de and trying to use PM82x project and boot linux
We have changed only the IMMR address and enabled debug messages in make menuconfig
We are finding that we are not able to get any messages as such .
So please tell what could be wrong ?
we are using console = ttyS0,9600
please help us
Regards
Arun
Quoted 3 lines · R Arun Kumar
We have changed only the IMMR address and enabled debug messages in make
menuconfig
LOL! Changing the IMMR is _huge_. Make
sure you have a good reason to do so and
understand all of the implications.
Quoted 1 line
we are using console = ttyS0,9600
console=ttyCPM0,9600
-- Dan
Quoted 7 lines · In message <[email protected]> you wrote:
We have a MPC8280 custom board and we are using u-boot-1.1.6 and successfully booting u-boot.
Now we are trying to compile linux 2.6.14 source available are www.denx.de and trying to use PM82x project and boot linux
Quoted 6 lines
We have changed only the IMMR address and enabled debug messages in make menuconfig
We are finding that we are not able to get any messages as such .
So please tell what could be wrong ?
Anything could be wront. For a start, you should *port* Linux to your baord, and not just make one single change and assume everything would fall in place.
And please note that all this is off topic on this list.
Best regards,
Wolfgang Denk
Signature · 4 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de To be sure of hitting the target, shoot first and, whatever you hit, call it the target.