Skip to contentSkip to conversation

Regarding MPC8280 boot

U-Boot-Users R Arun Kumar 3 participants 3 messages Nov 29, 2006

lore
Share & tools
lore
#1 lore raw
In reply to R Arun Kumar
Quoted 3 lines · R Arun Kumar

We have changed only the IMMR address and enabled debug messages in make
menuconfig

LOL! Changing the IMMR is _huge_. Make
sure you have a good reason to do so and
understand all of the implications.

Quoted 1 line

we are using console = ttyS0,9600

console=ttyCPM0,9600

	-- Dan
#0 lore raw

Hai All

We have a MPC8280 custom board and we are using u-boot-1.1.6 and successfully booting u-boot.

Now we are trying to compile linux 2.6.14 source available are www.denx.de and trying to use PM82x project and boot linux

We have changed only the IMMR address and enabled debug messages in make menuconfig

We are finding that we are not able to get any messages as such .

So please tell what could be wrong ?

we are using console = ttyS0,9600

please help us

Regards
Arun

#2 lore raw
Quoted 7 lines · In message <[email protected]> you wrote:

We have a MPC8280 custom board and we are using u-boot-1.1.6 and successfully booting u-boot.

Now we are trying to compile linux 2.6.14 source available are www.denx.de and trying to use PM82x project and boot linux

Quoted 6 lines

We have changed only the IMMR address and enabled debug messages in make menuconfig

We are finding that we are not able to get any messages as such .

So please tell what could be wrong ?

Anything could be wront. For a start, you should *port* Linux to your baord, and not just make one single change and assume everything would fall in place.

And please note that all this is off topic on this list.

Best regards,

Wolfgang Denk

Signature · 4 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
To be sure of hitting the target, shoot first and, whatever you  hit,
call it the target.