Neep help with my MMC driver ...
A message that is not in the archive (sent off-list or not yet received): 000c01c7cad4$127dcba0$377962e0$@[email protected]
Quoted 6 lines · On Fri, 20 Jul 2007 15:44:18 +0200 "Pierre Savary" <[email protected]>…
Hi,
I permit me to send you a mail because I've seen on the net that you have work around MMC.
Well, I am the maintainer ;)
Also, you should include the LKML for these discussions.
Quoted 6 lines
Linux 2.6.21+patch.AT91 run on my AT91sam9260. I must use the MMC. But it doesn't work . and I try since the begin of this week !!!!!!!! This is what I do :
*snip*
Quoted 3 lines
$ mknod /dev/mmc b 254 0
Make sure this is the correct major. You can find it in /proc/devices.
*snip*
Quoted 14 lines
Sending command 1 as 00001041, arg = 00000000, blocks = 0, length = 0 (MR = 00008384)
setting ier to 00000001
MCI irq: status = 0001C0E4, C07F0001, 00010000
MMC: Response index error
Completed command
Status = 0009C0E4 [00000000 00000000 00000000 00000000]
Quoted 8 lines
Error detected and set to 4 (cmd = 1, retries = 0)
mmc0: req done (CMD1): 4/0/0: 00000000 00000000 00000000 00000000
mmc0: clock 0Hz busmode 1 powermode 0 cs 0 Vdd 0 width 0 timing 0
MMC: Setting controller bus width to 1
All your commands are failing, oddly enough with "response index error". I'm not familiar with the AT91 controller, so I'm adding Nicolas Ferre, the AT91 maintainer, to this discussion.
Rgds
Signature · 5 lines
-- Pierre Ossman Linux kernel, MMC maintainer http://www.kernel.org PulseAudio, core developer http://pulseaudio.org rdesktop, core developer http://www.rdesktop.org
Pierre Ossman :
Quoted 7 lines
Quoted 4 lines · On Fri, 20 Jul 2007 15:44:18 +0200 "Pierre Savary" <[email protected]>…
Hi,
Quoted 10 lines
Quoted 2 lines
I permit me to send you a mail because I've seen on the net that you have work around MMC.
Well, I am the maintainer ;)
Also, you should include the LKML for these discussions.
Quoted 3 lines
Linux 2.6.21+patch.AT91 run on my AT91sam9260. I must use the MMC. But it doesn't work . and I try since the begin of this week !!!!!!!! This is what I do :
Please use the very last patchset developed those last days for at91_mci.
Regards,
Signature · 1 line
Nicolas Ferre